Extender for HDMI over one CAT5

®
®
1080P
Extender for HDMI
over one CAT5
GTV-HDBT-CAT5
User Manual
gefentv.com
ASKING FOR ASSISTANCE
Technical Support:
Telephone
(818) 772-9100
(800) 545-6900
Fax(818) 772-9120
Technical Support Hours:
8:00 AM to 5:00 PM Monday through Friday, Pacific Time
Write To:
Gefen, LLC.
c/o Customer Service
20600 Nordhoff St
Chatsworth, CA 91311
www.gefentv.com
[email protected]
Notice
Gefen, LLC reserves the right to make changes in the hardware, packaging and
any accompanying documentation without prior written notice.
Extender for HDMI over one CAT5 is a trademark of Gefen, LLC
HDMI, the HDMI logo, and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing in the United States and
other countries.
© 2013 Gefen, LLC. All rights reserved.
All trademarks are the property of their respective owners.
Rev A3
CONTENTS
1
Introduction
2
Operation Notes
3
Features
4
Sender Unit Layout
5
Sender Unit Descriptions
6
Receiver Unit Layout
7
Receiver Unit Descriptions
8
Connecting the Extender for HDMI over one CAT5
8
9
Wiring Diagram
Network Cable Wiring Diagram
10 Wall Mounting Instructions
11 Specifications
12Warranty
INTRODUCTION
Congratulations on your purchase of the Extender for HDMI over one CAT5.
Your complete satisfaction is very important to us.
GefenTV
GefenTV is a unique product line catering to the growing needs for innovative
home theater solutions. We specialize in total integration for your home theater,
while also focusing on going above and beyond customer expectations to ensure
you get the most from your hardware. We invite you to explore our distinct
product line and hope you find your solutions. Don’t see what you are looking for
here? Please call us so we can better assist you with your particular needs.
The GefenTV Extender for HDMI over one CAT5
The GefenTV Extender for HDMI over one CAT5 uses one CAT-5e (or better)
cable to extend 1080p Full HD and 3DTV over 230 feet (70 meters) away from
its HDMI or DVI-D source. It also supports high bit-rate audio formats such as
Dolby® TrueHD and DTS-HD® Master Audio™.
3D content can be displayed when a 3D-capable display and 3D source are
connected. DVI-D is also supported when used with an HDMI to DVI Adapter,
providing greater flexibility and options when integrating several home theater
components.
By using standard CAT-5e cables, it makes HDMI signal extensions easier to
install within a room or through walls. The Extender’s pure digital transmission
method insures 100% signal integrity over long distances.
How It Works
The GefenTV Extender for HDMI over one CAT5 Extender system consists of a
Sender and a Receiver unit. The HDMI source (such as a set-top box, Blu-ray
player, or gaming console) connects to the Sender unit with the supplied 6-foot
HDMI cable. The Receiver unit connects to the HDTV display, up to 230 feet (70
meters) away. One CAT-5e cable links the Sender to the Receiver unit. Power
is applied to the Sender and the Receiver with the two included 5V DC power
supplies. A crisp, flawless High-Def picture appears on the HDTV display.
1
OPERATION NOTES
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE EXTENDER FOR HDMI OVER ONE CAT5
•
CAT-5 or CAT-6 cables should not exceed 230 feet (70 meters).
•
Shielded (STP) CAT-5 or CAT-6 is recommended. However, unshielded
(UTP) CAT-5 or CAT-6 is acceptable, depending on cable quality, but is not
the top choice. Care should always be given to keep these cables away from
power lines and other electromagnetic interference sources.
NOTE: Shielded cable has an advantage by providing immunity
to Electromagnetic Interference (EMI) from cell phones and A/C
motors.
•
This product is Ultra HD 4K x 2K compliant. 4K x 2K resolutions can be
extended up to 130 feet (40 meters) over a CAT-5e cable.
•
HDBaseT ® technology allows HDMI, IR (Bi-directional), and power to be
sent on one CAT-5e/6 cable.
2
FEATURES
HDMI Features Supported
•
Ultra HD 4K x 2K (3840 x 2160 @ 30Hz)
•
1080p Full HD
•
12 bit Deep Color
•
HDCP
•
Dolby® TrueHD, DTS-HD® Master Audio™, and PCM digital audio up to 7.1
channels
•
Deep Color
•
LCPM 7.1 Audio, Dolby® TrueHD and DTS-HD Master Audio™
pass-through
•
3DTV pass-through
•
Lip Sync pass-through
Features
•
Extends HDMI at 1080p Full HD up to 230 feet (70 meters) over one
CAT-6A and up to 200 feet (60 meters) over one CAT-5e cable
•
Extends HDMI at 4K x 2K (3840 x 2160 @ 30Hz) up to 130 feet (40 meters) over one CAT-5e cable
•
Uses HDBaseT® Technology
•
Built-in automatic video signal equalization
•
Locking power supplies
•
Easy surface mounting with included Mounting Plates
Package Includes
(1) Extender for HDMI over one CAT5 - Sender unit
(1) Extender for HDMI over one CAT5 - Receiver unit
(1) 6 ft. HDMI cable (M-M)
(2) 5V DC Locking Power Supplies
(1) Set of Mounting Plates
(1) Quick Start Guide
3
SENDER UNIT LAYOUT
Front
1
Back
2
3
4
4
SENDER UNIT DESCRIPTIONS
1
Link
Connects the Sender to the Receiver unit using CAT-5e (or better) cabling.
2
5V DC
Connect the included 5V DC locking power supply to this connector. Only use
the power supply shipped with this unit.
3
Power
This LED will glow bright blue once the included 5V DC locking power supply
has been properly connected to the unit and the locking power supply has been
connected to an available wall outlet.
4
HDMI In
Connect a Hi-Def source device to this HDMI port. Please see the Features
section on page 3 for supported HDMI features.
5
RECEIVER UNIT LAYOUT
Front
1
Back
2
3
6
4
RECEIVER UNIT DESCRIPTIONS
1
Link
Connects the Receiver unit to the Sender unit using CAT-5 (or better) cabling.
2
HDMI Out
Connect an HDTV to this HDMI port. Please see the Features section on
page 3 for supported HDMI features.
3
Power
This LED will glow bright blue once the included 5V DC locking power supply
has been properly connected to the unit and the locking power supply has been
connected to an available wall outlet.
4
5V DC
Connect the included 5V DC locking power supply to this connector. Only use
the power supply shipped with this unit.
7
CONNECTING THE EXTENDER FOR HDMI OVER ONE CAT5
How to Connect the Extender for HDMI over one CAT5
1. Position the Extender for HDMI over one CAT5 Sender unit near the Hi-Def
source and the Receiver unit next to the display. Connect the Hi-Def source to
the Sender with the provided locking HDMI cable. Connect the HDTV display
to the Receiver unit with an HDMI cable.
2. Connect the Sender and Receiver units together using a single CAT-5e
or CAT-6 cable up to 230 feet (70 meters). 4K x 2K resolutions can be
extended up to 130 feet (40 meters).
NOTE: If terminating network cables in the field, please adhere to
the TIA/EIA568B specification (see page 9).
3. Connect the included locking power supplies to the Sender and Receiver
unit. Do not overtighten the locking connectors. Plug the two power
supplies into available wall outlets. The LED on both the Sender and
Receiver will turn bright blue, indicating that both units are powered.
Wiring Diagram for the Extender for HDMI over one CAT5
CAT5 CABLE
HDMI CABLE
®
Hi-Def Source
Receiver
Sender
HD Display
GTV-HDBT-CAT5
8
NETWORK CABLE WIRING DIAGRAM
Gefen recommends the TIA/EIA-568-B wiring option. Please adhere to the table
below when field terminating cable for use with Gefen products.
Pin
Color
1
Orange / White
2
Orange
3
Green / White
4
Blue
5
Blue / White
6
Green
7
Brown / White
8
Brown
12345678
CAT-5, CAT-5e, and CAT-6 cabling comes in stranded and solid core types.
Gefen recommends using solid core cabling. CAT-6a cable is also recommended.
It is recommended to use one continuous run from one end to the other. In some
cases, connecting through a patch might not work.
9
WALL MOUNTING INSTRUCTIONS
The GefenTV Extender for HDMI over one CAT5 should be mounted vertically
on a wall or inside / outside a cabinet with wood / drywall screws as shown in the
diagram above. There should be an inch or two of clearance between the edges
of the unit and any walls or vertical surfaces to allow for enough clearance for
connection and disconnection of the HDMI cable.
For installation on a drywall surface, use a #6 drywall screw. When installing, it is
recommended to use the center hole on a stud.
10
SPECIFICATIONS
Maximum Pixel Clock................................................................................300 MHz
Video Input Connector (Sender)...........................(1) HDMI Type-A, 19-pin, female
Video Output Connector (Receiver).....................(1) HDMI Type-A, 19-pin, female
Link Connectors (Sender / Receiver).........................................(1) RJ-45, shielded
Power Indicators (Sender / Receiver).....................................................LED (blue)
Power Supplies...........................................................................(2) 5V DC, locking
Power Consumption.................................................................10W per unit (max.)
Operating Temperature ..............................................+32 to +104 °F (0 to +40 °C)
Dimensions (W x H x D)........................3.2” x 1.3” x 3.3” (80mm x 27mm x 83mm)
Shipping Weight.................................................................................3 lbs. (1.4 kg)
11
WARRANTY
Gefen warrants the equipment it manufactures to be free from defects in material
and workmanship.
If equipment fails because of such defects and Gefen is notified within two (2)
years from the date of shipment, Gefen will, at its option, repair or replace the
equipment, provided that the equipment has not been subjected to mechanical,
electrical, or other abuse or modifications. Equipment that fails under conditions
other than those covered will be repaired at the current price of parts and labor in
effect at the time of repair. Such repairs are warranted for ninety (90) days from
the day of reshipment to the Buyer.
This warranty is in lieu of all other warranties expressed or implied, including
without limitation, any implied warranty or merchantability or fitness for any
particular purpose, all of which are expressly disclaimed.
1. Proof of sale may be required in order to claim warranty.
2. Customers outside the US are responsible for shipping charges to and from
Gefen.
3. Copper cables are limited to a 30 day warranty and cables must be in their
original condition.
The information in this manual has been carefully checked and is believed to
be accurate. However, Gefen assumes no responsibility for any inaccuracies
that may be contained in this manual. In no event will Gefen be liable for
direct, indirect, special, incidental, or consequential damages resulting from
any defect or omission in this manual, even if advised of the possibility of such
damages. The technical information contained herein regarding the features and
specifications is subject to change without notice.
For the latest warranty coverage information, refer to the Warranty and Return
Policy under the Support section of the Gefen Web site at www.gefen.com.
PRODUCT REGISTRATION
Please register your product online by visiting the Register Product page
under the Support section of the Gefen Web site.
12
Rev A3
20600 Nordhoff St., Chatsworth CA 91311
1-800-545-6900
818-772-9100
www.gefentv.com
Pb
This product uses UL listed or CE compliant power supplies.
fax: 818-772-9120
[email protected]