docSchlage Anti-Ligature Sales Presentation
download 
Report Transcription
Schlage Anti-Ligature Sales Presentation
Schlage L-Series Locks Anti Ligature Solutions Anti-Ligature Training Presentation September 1, 2011 © 2011 Ingersoll Rand Agenda g Introduction Statistics P d t Overview Product O i FAQs 2 Anti-Ligature Solution Company Confidential – for internal use only Introduction • Suicide is the 11th leading g cause of death in the United States,, with over 31,000 people taking their life annually. 1,500 suicides occur while in hospitals1; it is also the leading cause of death while incarcerated4. Ligature g strangulation g ((hanging) g g) is the primary means used to end one’s life in these environments. • Schlage S hl now offers ff a complete l t solution l ti specifically ifi ll d designed i d to reduced the risk of injury or death due to hanging for use in psychiatric wards, mental health facilities, and detention centers. t Anti-ligature A ti li t kknobs, b llevers, thumbturns, th bt and d cylinder li d rings combined with IVES anti-ligature door hinges offer substantial patient protection along with differentiation from competitors. 3 Anti-Ligature Solution Company Confidential – for internal use only Introduction Statistics P d t Overview Product O i FAQs 4 Anti-Ligature Solution Company Confidential – for internal use only Suicide Statistics • US General Statistics – 11th leading cause of death (homicide is 13th)2 – 3rd leading cause of death for 15-24 year olds2 – 32,637 suicides, over 800k attempts in 20052 • Hospital Statistics – ~1500 suicides in inpatient p hospital p units annually y3 – Doors/door hardware involved in 28% of all suicides3 • Jail Statistics • Suicide is leading cause of death in jails (29%)4 • Juvenile Confinement Statistics • Includes detention centers, training schools, ranches, camps 5 • Door/door hardware involved in over 21% of suicides 5 5 Anti-Ligature Solution Company Confidential – for internal use only Facility y Statistics • • • • 5,795 5 795 hospitals (includes 444 psychiatric hospitals)6 3,375 state or county jails7 2 939 juvenile detention centers8 2,939 179 federal prisons9 6 Anti-Ligature Solution Company Confidential – for internal use only Introduction Statistics P d t Overview Product O i FAQs 7 Anti-Ligature Solution Company Confidential – for internal use only SK1 and SL1: Anti-Ligature g Knob & Lever • Door hardware specifically designed to reduce the ability to injure through hanging (ligature strangulation). • Available as knob ((SK1)) or lever (SL1). ( ) Thumbturn and cylinder also specially designed as anti-ligature. • For L series Mortise Locks only; available as option or retrofit. retrofit 8 Anti-Ligature Solution Company Confidential – for internal use only 5 Facets of Anti-Ligature Safety g y I Recessed Trim Ti V Internal Clutch in Lever Increased Safety IV Thumbturn & Cylinder 9 Anti-Ligature Solution II Slope on non-vertical Surfaces III Concealed Mounting Hardware Company Confidential – for internal use only I. Recessed Trim • Rose and thumbturn are recessed to reduce apparent gap between trim, minimizing opportunity for securing a ligature. Minimal seam in door trim I Recessed Trim V Internal Clutch in Lever IV Thumbturn & Cylinder Increased Safetyy II 20° Slope on nonvertical Surfaces III Concealed Mounting Hardware 10 Anti-Ligature Solution Company Confidential – for internal use only II. Slope p on Surfaces • All non non-vertical vertical surfaces angled to decrease opportunity for attachment to trim. I Recessed Trim IV Thumbturn & Cylinder Increased Safetyy II Slope on nonvertical Surfaces Kno ob Lev ver V Internal Clutch in Lever Cylinde er Thumbtu urn No flat surfaces to attach ligature III Concealed Mounting Hardware 11 Anti-Ligature Solution Company Confidential – for internal use only III. Concealed Hardware • All mounting hardware concealed or recessed recessed, eliminating opportunity to secure a ligature. No exposed hardware I Recessed Trim V Internal Clutch in Lever IV Thumbturn & Cylinder Increased Safetyy II Slope on non-vertical Surfaces Hardware recessed III Concealed Mounting Hardware SL1 Lever Shown 12 Anti-Ligature Solution Company Confidential – for internal use only IV. Thumbturn and Cylinder y • ADA compliant thumbturn has a sloped surface and positive stops to prevent over-rotation and presentation of horizontal surface (possible ligature point). Cylinder ring has sloped trim, again minimizing attachment opportunity. Positive stops turn never goes horizontal I Recessed Trim V Internal Clutch in Lever Increased Safetyy IV Thumbturn & Cylinder Sloped p Surface II Slope on non-vertical Surfaces III Concealed Mounting Hardware 13 Anti-Ligature Solution Company Confidential – for internal use only V. Internal Clutch ((Lever only) y) • SL1 lever free free-rotates rotates if excessive force applied applied. Mechanism self-contained so compatible with all L locks. Resets by moving handle back to normal position. Not applicable to SK1 due to round shape of knob. I Recessed Trim V Internal Clutch in Lever IV Thumbturn & Cylinder Increased Safetyy II Slope on non-vertical Surfaces III Concealed Mounting Hardware 14 Anti-Ligature Solution Company Confidential – for internal use only Part Overview – SK1 Knob Thumbturn Cylinder Inside Knob Outside Knob 15 Anti-Ligature Solution Company Confidential – for internal use only Part Overview – SL1 Lever Thumbturn Cylinder Inside Lever Outside Knob 16 Anti-Ligature Solution Company Confidential – for internal use only Simple p Installation • Follows standard L L-Series Series door prep; simply replace handle/thumbturn/cylinder with anti-ligature version. 17 Anti-Ligature Solution Company Confidential – for internal use only Anti-Microbial Option p • Anti-Microbial Anti Microbial option is a coating applied at • • • • • the factory that lasts the lifetime of the product Silver-ion based finish inhibits cell viabilityy byy limiting g ability to absorb oxygen, process food, or reproduce Effective against bacteria, mold, fungus, mildew, algae. Coating supplier EPA registered, FDA listed under 21CFR 175.300 Available for both SK1 knob and SL1 lever Add ‘AM’ to finish suffix (i.e., 630AM) 18 Anti-Ligature Solution Company Confidential – for internal use only Anti-Ligature g Hinge g • Complements anti anti-ligature ligature knob & lever by minimizing door hardware attachment point. • Order through g IVES - specify p y HT ((hospital p tip) p) as hinge g option (available on all IVES butte and pin and barrel continuous hinges) Traditional hinge with flat tip presents li t ligature attachment tt h t opportunity 19 Anti-Ligature Solution Angled “hospital tip” minimizes attachment opportunity Company Confidential – for internal use only Introduction Statistics P d t Overview Product O i FAQs 20 Anti-Ligature Solution Company Confidential – for internal use only FAQs • What is the difference between an anti-ligature anti ligature knob and anti anti-ligature ligature lever? Both the Schlage SK1 anti-ligature knob and SL1 anti-ligature lever offer increased patient protection by minimizing apparent attachment points on the door hardware. Deciding between the two solutions is a matter of preference, although only the SL1 lever is ADA compliant compliant. • Is this different than the Schlage Prison Knob from several years ago? Yes – the SK1 knob differs from the XPO knob of the p past in that it is significantly g y easier to grip, twist, and pull. This allows for increased ease of use, and a wider variety of applications. • When will the product be available? The SK1 anti-ligature knob, thumbturn and cylinder are currently available. The SL1 anti-ligature knob is available to order now, with product delivery starting in May 2011. 21 Anti-Ligature Solution Company Confidential – for internal use only FAQs • What are the normal lead times for the product? You can expect a lead time of 6 weeks for the Anti-Ligature knob or lever. • Can I mix-and-match anti-ligature knobs and levers with each other or with other L-series knobs and levers? You can mix the anti-ligature knob and lever, but you cannot mix an anti-ligature knob or lever with a traditional knob or lever. • What claims can be made about the product? As you can imagine, careful consideration needs to be given before claiming any product performance characteristics. Anything that is published in the public lit t literature is i approved db by llegall ffor your use. Pl Please d do nott expand d or paraphrase h beyond what you see in print. 22 Anti-Ligature Solution Company Confidential – for internal use only FAQs • Is there a cylindrical lock or Falcon version available? No - the trim is only offered on the L-Series mortise lock. • Are there any other restrictions with the Schlage Anti-Ligature Trim? This trim is not available with "L" cylinder option (Lock Less Cylinder), LLL (lock less case), Lock less components, standard ADA thumbturn (L583-363), tactile or knurling. knurling 23 Anti-Ligature Solution Company Confidential – for internal use only A Appendix di 24 Anti-Ligature Solution Company Confidential – for internal use only Sources 1 Center for Disease Control and Prevention 2 suicide.org 3 The Joint Commission Journal on Quality and Patient Safety, Impatient Suicide and Suicide Attempts in Veterans Affairs Hospitals, August 2008 4 US Dept of Justice, Bureau of Justice Statistics, Mortality in Local Jails 20002007 5 Juvenile Suicide in Confinement: A National Survey, y, National Center on Institutions and Alternatives 6 American Hospital Association, 2009 Data 7 Sourcebook of Criminal Justice Statistics 2003 (data from 1999) 8 Office of Juvenile Justice and Delinquency Prevention (data from 1999) 9 Federal Bureau of Prisons, www.bop.gov 25 Anti-Ligature Solution Company Confidential – for internal use only
