Clubmaker Shaft Cutting Table

Clubmaker Shaft Cutting Table
Stock #245243
The Golfsmith Shaft Cutting Table allows a clubmaker
to trim an entire set of wood or irons shafts in a single
cut. With the Shaft Cutting Table anchored to a
14” full size cut-off saw (not included) shafts can
quickly be fixtured to trim in either 1/2” or1/4” increments.
Prior to table operation the
base requires to be secured
together using the four
enclosed bolts.
To properly set up the Shaft Cutting Table to a cut-off saw begin
by taking a ruler or yard stick and placing it flush against the
unmoving saw blade. Line up the Cutting Table ruler with the
ruler against the saw blade to calibrate the proper cutting length
prior to securing the table to the saw.
Adjustable legs permit the
Shaft Cutting Table to suit
most any 14” cut-off saw.
1/2” increment template
The longest shaft
of the set should
be positioned to
appropriate length
at this point.
Loosen the two side
knobs to slide the
template platten
to the desired cut
length position.
Two spring-tightened swivel clamping bars
hold the shafts steady while cutting.
1/4” increment template
11000 North IH-35, Austin, TX 78753, USA
(512) 837-4810
www.golfsmith.com