I

Transcription

I
Nursing Practice
Practice educator
Inhaler technique
Keywords: Asthma/COPD/Inhalers
●This article has been double-blind
peer reviewed
When individuals are first prescribed inhaled medication it is essential to teach
them about the correct use of their inhaler to ensure optimal drug delivery
How to teach
inhaler technique
In this article...
The importance of using inhalers correctly
Detailing different types of inhalers and how to use them
Correctly using training aids
I
nhalation is the preferred method of
delivering medication for respiratory
conditions such as asthma and chronic
obstructive pulmonary disease (COPD).
The drug is delivered directly to the affected
organ, allowing a lower dose to be used.
The need for teaching
Incorrect use of inhalers reduces any
potential benefit of the medication, so respiratory guidelines recommend that
patients are carefully taught how to use
prescribed inhalers (British Thoracic
Society/Scottish Intercollegiate Guidelines
Network, 2008).
Most pressurised metered dose inhalors
(pMDIs) involve users coordinating correct timing and appropriate inspiratory
flow rate (IFR). Some pMDIs (Autohaler,
Easibreathe) and all dry powder inhalers
(DPIs) do not require timing, but do
demand that the inspiration produces a
certain IFR or peak inspiratory flow (PIF).
Written instructions alone on how to
use an inhaler are insufficient. When
patients are first prescribed inhaled medication they must be taught how to use
their inhaler, and their technique should
be checked at subsequent consultations.
It is crucial that health professionals
who teach inhaler technique can perform
it correctly themselves (Crompton et al,
2006). However, a recent study showed
that 93% of those tested were unable to
demonstrate both the various stages of
inhaler use and the correct IFR (Baverstock
et al, 2010). The techniques and IFRs are
not the same for all devices, so health professionals must learn how to use all the
inhalers they prescribe. For all inhalers the
instructions in the patient information
leaflet should be followed.
Pressurised metered dose inhalers
pMDIs consist of a pressurised canister
containing the medication. When the
inhaler is activated by pressing the canister, releasing a measured aerosol dose of
the drug, the user must inhale slowly at a
low IFR; if they don’t do this, most of the
respirable dose will stick to the back of the
throat rather than reaching the lungs (Box
1). This requires a degree of coordination
that may be beyond the ability of some,
such as children or older people.
For those who find pMDI technique difficult or need a high dose of corticosteroid,
a spacer device can be attached to the
inhaler. After the canister is pressed, the
medication remains in suspension in the
spacer for a short time allowing the user to
inhale the drug by either taking one deep
gentle breath in or through tidal breath
(inhale and exhale at normal, resting rate –
this is usually at a rate of one press of the
inhaler and five tidal breaths).
A spacer with a mask attached is available for children and adults who have difficulty sealing their lips around a mouthpiece. The mask must be closely applied to
the face while the pMDI is activated. Manufacturers recommend washing spacer
devices in warm soapy water when new,
and then weekly, leaving to air dry to
reduce static.
Spring-loaded pMDIs (Autohaler/
Easibreathe)
These inhalers must be primed before each
use. The Autohaler is primed by pushing a
16 Nursing Times 01.03.11 / Vol 107 No 8 / www.nursingtimes.net
lever on top of the inhaler upwards and the
Easibreathe by closing the cap on the
mouthpiece. The devices are activated
when the user inhales, which removes the
need to coordinate activation and inspiration, although an appropriate IFR and continued breathe-in is still vital.
Fine mist pMDI (Respimat)
This device requires initial priming and
activation in accordance with the manufacturer’s instructions. The outer case is
turned before each use and the cap is
removed. The lips should then be sealed
around the mouthpiece before the device
is activated. A long, gentle breath in is
required.
Dry powder inhalers
A wide range of DPIs is available; Box 2 outlines how to use them. The list below is not
exhaustive but explains how some of those
most commonly prescribed in the UK
work. The drug is held within sealed blisters, capsules or a reservoir and the inhaler
prepared by, for example:
» Pressing a trigger, which moves an
opened blister to the inhalation port
(Accuhaler);
» Loading and piercing the capsule
(Handihaler);
» Twisting the base of the reservoir
(Turbohaler).
Inhalation breaks up the powder into an
aerosol of respirable sized particles,
drawing the drug out of the inhaler into the
lungs. This means a more forceful inspiration is required when using a DPI, compared with a pMDI, although the PIF needed
varies according to the inhaler’s design.
For a Nursing Times Learning unit
on arterial blood gases, go to
nursingtimes.net/ABG2
Box 1. using pmdis
● Remove the cap
● Shake the inhaler
● Breathe out gently
● Place mouthpiece between
lips
● Actuate the inhaler and
breathe in slowly and deeply at a
low inspiratory flow rate
● Hold breath for 5-10 seconds
then breathe out
● Wait a few seconds then
repeat the process if the second
dose is needed
● Replace inhaler cap
Box 2. Using DPIs
● Remove cap
● Prime device for delivery
● Breathe out gently
● Place mouthpiece between
lips
● With Accuhaler breathe in
steadily and deeply
● With Turbohaler and
Placebo inhalers, which are available from
inhaler manufacturers, can help with
demonstrating correct inhaler technique.
It is important to note that these placebo
devices are for single-person use only.
A range of devices is available to help
train health professionals and patients.
These include: 2Tone Trainer Turbutest,
In-CheckDial, Mag-Flo inhaler flow indicator, Aerosol Inhalation Monitor, Inhalation Manager, SmartMist and Multimedia
training tools (Lavorini et al, 2010).
Summary
If adherence with therapy is to be
achieved, when selecting a suitable device
it is important to take into account individuals’ ability to use inhalers as well as
their attitude towards their disease,
therapy and the acceptability of the
selected device. Adherence and inhaler
technique should be assessed at every
consultation. NT
Linda Pearce is respiratory nurse consultant
and clinical lead, Suffolk COPD Services
References
Baverstock M et al (2010) Do healthcare professionals
have sufficient knowledge of inhaler technique in order
to educate their patients effectively in their use?
Thorax; 65: (Suppl 4), A119.
British Thoracic Society, Scottish Intercollegiate
Guidelines Network (2008) British guideline on the
management of asthma. Thorax; 63: (suppl.4), 1-121.
Crompton G et al (2006) The need to improve
inhalation technique in Europe: a report from the
Aerosol Drug Management Improvement Team.
Respiratory Medicine; 100: 1479-1494.
Lavorini F et al (2010) The ADMIT series – Issues in
inhalation therapy. Training tools for inhalation devices.
Primary Care Respiratory Journal; 19: 4, 335-341.
Dry powdered
inhalers require
less coordination
than standard
metered dose
inhalers
5 key
points
1
Failure to use
inhalers correctly
reduces their
benefit
Patients should
be taught how
to use their inhaler
when they are first
prescribed inhaled
medication
Their technique
should be
checked at
subsequent
consultations
Individuals’
abilities should
be taken into
account when
selecting inhaler
devices
Placebo
inhalers can be
useful to
demonstrate
correct inhaler
technique
2
3
4
5
Box 3.
Competencies
required by
nurses
● Ability to carry out loading
and activation procedure for the
various inhalers
● Knowledge of appropriate
inspiratory flow rates for
pressurised metered dose
inhalers, and peak inspiratory
flows for dry powder inhalers
● Ability to understand and
teach how to use each inhaler
● Ability to recognise poor
inhaler technique
Box 4. details
to Document
● Diagnosis and disease
severity
● Type of inhaler and appropriate inspiratory flow rate/peak
inspiratory flow (this may
change if inhaler is changed)
● Checklist of correct inhaler
use (Boxes 1 and 2)
● Details of reinstruction and
re-checking where necessary
● If inhaler device has been
changed, state the reason
for this
www.nursingtimes.net / Vol 107 No 8 / Nursing Times 01.03.11 17
SPL
Training aids
Handihaler breathe in as deeply
as possible
● Hold breath for 5-10 seconds
● Wait a few seconds then
repeat process if a second dose
is needed
● Replace inhaler cap