How to configure WAN to WWAN Failover on AirCard Hub

How to configure WAN to WWAN Failover on AirCard
Hub
Pre-Requisites:
1.
2.
3.
4.
Sierra Wireless AirCard Hub
Sierra Wireless AirCard 760S
PC, Laptop, Tablet or Smartphone to set it all up
Ethernet to your fixed internet connection
1. Connect your fixed internet connection to the AirCard Hub via a LAN cable. Make sure to plug
LAN cable into port that is marked blue on the back of the AirCard Hub like below:
2. Sit AC760s in the cradle and wait for icons on screen to show that its successfully using the
Hub like below:
3. Log into the AirCard Hub via WiFi and open up the WebUI via an internet browser by typing
http://swi.hub into the address bar like below:
4. Enable Power User mode by checking the Power User option
5. Click on Switch to advanced view to take you to login screen.
6. Log into the WebUI with user: admin pass: admin and click submit.
7. On the next screen you will need to switch the Hub to WAN mode. You can do this by
selecting WAN from the dropdown list under the heading Ethernet Port Status at the bottom
of the page:
8. When you see the below prompt click OK to continue:
9. If the settings were successfully applied you should now see CURRENT WAN like below in the
list:
10. From the menus at the top of the page Highlight Internet Settings then select WAN
11. From the drop down list under the heading Fail-over Settings select WWAN Failover if WAN
Link down and click Save
You have no successfully configured the AirCard Hub to failover to AC760S if your fixed
internet connection is down!!!!!
You can test this by just unplugging the LAN cable to see if it switches to AC760S. It should
switch over instantly.