HF SDR S/H Sample and Hold Receiver DR2B from 30... it Simple as Possible with Outstanding Performances

HF SDR S/H Sample and Hold Receiver DR2B from 30 KHz to 35 MHz-Make
it Simple as Possible with Outstanding Performances
Dipl. Ing . Tasić Siniša –Tasa YU1LM/QRP
All rights reserved, project is free for personal use only
Many HAMs all over the world built my SDR S/H receivers DR1, DR2, DR2A,
DR1A…. you can see some photos on my sites and I can noticed that they are all mainly
satisfied with results . Simple constructions with cheap classic components working really very
well. Also I find at INTERNET that some solutions from my receivers/transmitters are used in
some new SDR projects. I made DR2B PCB as product from DR3X receiver .Here is one of 3
possible connection for DR3X for external local oscillator with new PCB very small compare to
DR3X PCB .This receiver is similar very much to DR2 but even simpler. All data, measurements
and adjustment are the same. I shall repeat it here. I am giving schematics, part placement and
PCB.
DR2B Single side PCB size is 95 x 65 mm
Measuring results which I made with HF S/H SDR receiver DR2B
1. Receiving range from 30 kHz to 35 MHz with external LO and Vcc=+6 V for digital ICs.
2. IIP3 27-29 dBm and it depends from setting and used programs (all with 16 bit sound
cards).
3. MDS -102-105 dBm also with 16 bit SB card Realtek AC97
4. Image rejection is possible adjust to 35-60 dB 12 kHz from center frequency.
5. Sensitivity 3-5 uV for 10 dB S/N ratio, max S/N ratio I measured was 70 dB. This
sensitivity is more than enough for frequency near to 20 MHz with adequate antenna
system, for higher frequency it is recommend increasing AF gain (10 Kohms increase to
increase to max 100 Kohms R4,R29,R30 and R15) or putting some RF preamplifier in
front of DR2B to lower F (noise figure) of receiver.
6. SFDR (Spurious free dynamic range) is 86-92 dB, this results are with signals spaced 5
kHz and more. Results are not changing very much if we spaced two signals to classical
20 kHz or more.
Some excellent performances with 3 IC are not without other side:
1. First and very big disadvantage is 4 times higher LO
2. Image rejection is changing through receiving bands and results are done for frequencies
12 kHz from central frequency
3. For external LO it is necessary input level around 1 Vp-p min for safe operation (for
lower LO drive operations are not sure especially for higher LO frequencies)!!!Simple
test that 74HC4053 is working is to measure with DMM (digital multi meter) Vcc/2 or
2.5 V +/-0.5 V at control pins 9 or 10. If it is not true we have a problem with input LO
level or input ICs 74AC74 or 74AC02.
DR2B adjustments are simple and done in two steps:
1. Adjust with universal instruments DMM (digital multi meter) that is resistance in
feedback potentiometer 5k +8K2 = 10 K.
2. Find some strong signal in the air 12 kHz away from zero or put signal from signal
generator to the input of DR2B and with 5 kOhm potentiometer adjust min unwanted
image signal in some SDR program. Additional image rejection adjusts in SDR
programs if this possibility exists function such as skew in Alberto I2PHD programs.
I wish you successful DR2B realization and I apologize for some possible mistakes. I
made great effort to make SDR projects and share them with all who are interesting for.
Anyway send me your comments positive or negative, results or photos of your realization
please.
VY 73/72 and GL in SDR homebrew Tasa YU1LM/QRP
[email protected]
References:
1. www.qsl.net/yu1lm/homebrew
2. http://forum.cqham.ru/viewforum.php ?f=28
3. [email protected] T03DSP UR3IQO http://users.ints.net/skidan/T03DSP
4. http://www.nitehawk.com/sm5bsz Leif LINARD
5. http://www.flex-radio.com SDR1000 Gerald AC5OG
6. http://www.njqrp.org/mbrproj/9850dds.html
www.analog.com/en/prod/0,,770_843_AD9850,00.html
http://www.qsl.net/pa3ckr/signalgenerator/
http://www.k6ese.com/DDS_Project.htm
http://ham.kiev.ua/pic/dds_ham2.html
http://www.qsl.net/om3cph/dds/rx.html
http://www.seboldt.net/k0jd/othervfo.html
http://perso.wanadoo.fr/f6itv/p2063001.htm
http://koti.netplaza.fi/~jonverro/ad9854.htm
http://www.labyrinth.net.au/~steve/freq/
http://members.aol.com/Dl4JAL/DDS.html
http://hem.passagen.se/communication/dds.html
7.
6.
Recent Advances in Shortwave Receiver Design Dr. Ulrich Rohde QST Nov 1992 page 53
RF Design 6/1995
Software LINK for SDR radio receiving and transmitting
1.
http://digilander.libero.it/i2phd/ SDRadio software ver 0.99
www.qsl.net/i2phd Alberto I2PHDhttp://gpsdo.i2phd.com/
2.
[email protected] <[email protected]>[email protected]
<[email protected]>Vittorio
3.
www.weaksignals.com WINRAD
4.
www.ciaoradio.com
5.
www.m0kgk.co.uk/sdr
6.
www.g8jcf.dyndns.org Peter G8JCF
7.
8.
9.
http://www.nitehawk.com/sm5bsz Leif LINARD
http://www.flex-radio.com SDR1000 Gerald AC5OG
dl6iak.ba-karlsruhe.de