Users manual dimmer muudi

Users manual muudi dimmer
Art no
SM07
Type
Electronic, wall box installation.
Function
Push on/off, turn for dimming.
Terminal block
2,5 mm2
Fuse
electronic
Input max
230V, +- 10%, 50Hz
EMC approval
EN55015
Class
2
Ta max
40 degree C
Tc min
-20 degree C
1)
Min load Watt
Max load Watt
Incandescent lamp ohm (not halogen)
35
600
230V halogen bulbs
35
500
12V AC transformer
35
600
Load Gu10/G9 LED bulbs
10
300
LED drivers *) see below
10
300
LK drivers tracks/seiling lamps
6W
300W
LK/NX dimmable GU10/G9 bul bs
3W
300W
General Electric 5W dimmable GU10
5W
300W
10W
300W
3700800 Etman GU10 5 W
5W
300W
3330187 Lumens downlight 7,5W
7,5
300W
3230177 Lumens GU10 5 W
ETM Øst GU10 7 W (long)
5W
7W
300W
300W
*)
Philips LED driver/SG COB Junistar Ex
1) Loads above refer to 25 degree C temperature, if higher room temperature load must be reduced. If several
dimmers are mounted vertical above one another, loads must be reduced according to illustration below. In
case of overload the fuse cut off 100%. Seek for the fault, before testing again main fuse for the 230V shall
be cut off and switched on again (ensure electronic fuse in dimmer to re-start). Minimum and maximum load
refer to the most common fabricates in the marked, exception may occur. Therefore always refer to bulb/lamp
supplier for recommended dimmer. Installation only by authorised company/installer.
100
90
80
70
60
50
40
30
20
10
0
-10 0 10 20 30 40 50 60 70 80 90 100
Extra on/off Swith
230V
50HZ
L
N
SD400/SD600
12V
on/off Swith
vender
230V
50HZ
L
N
SD400/SD600
12V
Electronic transformer
12V
Electronic transformer
12V
Electronic transformer
Electronic transformer