SCHÖNOX AB ®

| SCHÖNOX AB
®
Product data sheet
8.09
Sealing and Uncoupling Layer
membrane made of polyethylene and covered with a special fleece installed using Schönox iFix sealing adhesive for commercial
and residential wet areas. Suitable for use under ceramic tiles and natural stones.
Product characteristics
MICODE EC 1PLUS: very low emission
E
h igh tensile strength
c rack bridging properties
rot proof
w ater resistant
impermeable to vapor
fl exible
easy to apply
for interior and exterior use
s uitable on screeds with floor heating
systems
c an be used as a separation layer
Applications
SCHÖNOX AB is a membrane for residential
and commercial wet areas such as:
i n heavy loaded commercial wet rooms
(public shower rooms, therapy rooms in
hospitals)
i n residential wet areas (bathrooms and
showers)
i n swimming pools prior to installations
of ceramic tiles. Officially approved for
pool depth of 10 m / 32.8 ft. using the
recommended SCHÖNOX Tile Adhesives.
o n balconies and terraces in combination
with the SCHÖNOX BALTERRA® -system.
Substrates
SCHÖNOX AB is suitable on:
concrete and cement based substrates
masonry (fully grouted)
g ypsum substrates
old substrates such as ceramic tiles, natural
stones and terrazzo
cement plaster, lime-cement plaster
g ypsum plaster
composite elements of polystyrene coated
with mortar
wall panels of leight weight concrete
g ypsum board
plywood, OSB boards
Requirements of substrate
ubfloors must be smooth, sound, clean,
S
dry and free of any contaminants which
may hinder adhesion.
S urface treatments or any “friable” areas of
the subfloor must be mechanically removed
back to a sound base and the substrate
repaired with SCHÖNOX repair compounds
as required.
O ld water-soluble adhesives should be
removed completely, old water-resistant
adhesives should be mechanically removed
as far as possible. The complete mechanical
removal of cutback (i.e. grinding, sanding,
blasting) can be hazardous as old cutback
adhesive may contain asbestos. Do not sand
or grind adhesive residue. Harmful dust may
result. Inhalation of asbestos dust may cause
asbestosis or other serious bodily harm.
Please consult the adhesive manufacturer
and all applicable government agencies
for rules and regulations concerning the
removal of flooring and adhesives that
contain asbestos. Prime remaining adhesive
residues accordingly.
O ld floors such as ceramic tiles should be
thoroughly cleaned and abraded.
T he requirements of the relevant valid
standards, guidelines and data sheets
apply.
P rime substrates following the product data
sheet of SCHÖNOX iFIX.
Recommended
working
method
Technical data
olor: grey
C
Sheet width: 1 m / 3.28 ft.
Roll length: 10 m / 32.8 ft.
Thickness: approx. 0.5 mm / 1/64“
Weight: approx. 280 g per m² / 0.06lb. per
sq.ft.
Temperature resistancy: -22°F up to 194°F
Working temperature: +41 ° F
Burst pressure: 3,9 bar / 56.57 psi
sd-rate: > 60 m / 196.8 ft.
UV-resistance: min. 500 hours
of
ut strips to size before using.
C
A pply SCHÖNOX iFIX using the SCHÖNOX iFIX ROLLER 180 mm and insert
the sheet membrane SCHÖNOX AB into the
fresh adhesive.
S CHÖNOX AB can be laid, within the open
time of approx. 15-20 minutes into the
fresh bed of sealing adhesive. Afterwards
press SCHÖNOX AB gently using the
SCHÖNOX iFIX TOOL avoiding air bubbles
beneath.
T he SCHÖNOX ST SEALING TAPE and the
SCHÖNOX ST-COMPONENTS are installed
beforehand with SCHÖNOX iFIX using the
SCHÖNOX iFIX ROLLER 100 mm.
E xpansion joints as well as floor and wall
connection joints are bridged, drains and
pipe are sealed using the SCHÖNOX ST
Accessories as required. The overlappings
are at least 5 cm.
To guarantee the function of the membrane,
this procedure must be carried out carefully.
Packaging
10 m 2 / 105 sq ft.
Storage
tore horizontal in cool, dry conditions
S
avoiding any deformation.
S helf life: 2 years
Disposal
S CHÖNOX AB is harmless and does not need
P-5121/802/11-MPA BS
P-5180/861/11-MPA BS
| SCHÖNOX AB
®
to be disposed as hazardous waste. Dispose
of in accordance with federal, state and
local waste disposal regulations.
VOC Content
0g/l (calculated), SCAQMD 1168
LEED
ay help contribute to LEED certification of
M
projects in the categories:
E Qc2
Low-Emitting Materials –
1 to 3 points
Instructions
Always install an adequate number of properly
located test areas to include the finish flooring,
to determine the suitability of the product for
its intended use. As ceramic tile coverings vary,
always contact and rely upon the manufacturer
for specific directions such as maximum
allowable
moisture
content,
adhesive
selection, and intended end use of the product.
Low substrate temperatures and/or high
ambient humidity require longer drying times
for primers.
Product data sheet
8.09
The applicable recommendations, guidelines,
regulations and safety data sheets are to
be obser ved, together with the recognized
architectural and engineering regulations. We
guarantee that our products leave the factor y in
perfect condition. While our recommendations
for
use
are
based
on
tests
and
practical
experience, they can only provide general
guidance without any assurance as to product
characteristics, since we have no influence
over the conditions on site, the execution of
the work or the method of processing. This
product data sheet supersedes all previous
editions.
Limitation of Liability
The SCHÖNOX management system is certified
to ISO 9001 and 14001 by DQS.
SCHÖNOX GmbH
P.O. Box 11 40
D-48720 Rosendahl/Germany
Phone
+49 (0) 2547-910-0
Fax
+49 (0) 2547-910-101
[email protected]
http://www.schonox.us
In North America provided by:
HPS North America, Inc
Phone:256.246.0345
Fax:256.246.0346
Email:[email protected]
http://www.hpsubfloors.com
B _0809us_14-08
To the best of our knowledge, the technical
data contained herein are true and accurate at
the date of issuance but are subject to change
without prior notice. We guarantee our product
to conform to the specifications contained
herein. We make no other warranty or
guarantee of any kind, express or implied,
including merchantability and fitness for
particular purpose. Liability, if any, is limited to
replacement of the product or refund of the
purchase price. Labor or cost of labor and other
consequential damages are hereby excluded.
SCHÖNOX does not authorize anyone, including
SCHÖNOX representatives, to make any
statements which supersede, modify or
supplement the information provided on its
printed literature or package labels without
written confirmation.