Polyethylene Separator with Laminated Glass Mat for Heavy

Transcription

Polyethylene Separator with Laminated Glass Mat for Heavy
Polyethylene Separator with Laminated Glass Mat for
Heavy Duty and Start-Stop Applications
ENTEK PE Glassmat separator consists of a 100% glass fiber retainer mat laminated to the
polyethylene separator. This is achieved by using a purpose-built laminaƟng machine to apply
a special adhesive to the ribs of the separator, and laminaƟng the glass mat to the separator
ribs. The resultant laminated separator material is supplied to the customer in roll form. It
can therefore be used on enveloping machines in the same way as the standard polyethylene
separator material.
ENTEK PE Glassmat should be specified in baƩery
applicaƟons where an excepƟonally heavy duty cycle
is anƟcipated e.g. regular deep discharges. Examples
include buses, taxis, commercial vehicles etc. The
glass retainer mat in contact with the posiƟve plate
helps to protect the acƟve material against shedding
in deep discharge and high vibraƟon condiƟons.
ENTEK PE Glassmat helps to extend baƩery life under
arduous operaƟng condiƟons, e.g. high ambient
temperatures and severe vibraƟon.
Typical profile drawing and dimensions
G
X
A
C
X
X
W
T
B
S
C
D
E
F
G
A
Separator width
Thickness
Backweb
Shoulder
Major rib spacing
Mini-rib spacing
Mini-rib radius
Shoulder rib height
Shoulder rib spacing
Land Area
Dimensions - mm
Any
0.6 - 1.4
0.15 - 0.25
16.5
18.14
3.02
0.18
0.10
0.825
5.0
B
T
F
Tolerance
 0.8
 0.08
 0.03
 4.5
(@ 160mm)
(@ 160mm)
E
PE Glassmat - Key technical data @ 0.15mm backweb (Base material only)
Tolerance
Nominal Value
4
5 max
%
Moisture
22 max
%
Oil content
0.08 max
0.065
Electrical resistance
.cm2
400
200 min
%
Elongation XMD
5 min
N
6.5
Puncture
55
%
Porosity
6
(Maximum ER dependent on profile)
(Typical dimensions as shown: other profiles may be available)
ENTEK is the leading world-wide producer of microporous polyethylene baƩery separators for lead-acid
baƩeries. ENTEK is privately held and headquartered in Lebanon, Oregon, USA with manufacturing faciliƟes
in Lebanon and Newcastle-upon-Tyne, U.K.
For more informaƟon:
[email protected]
or call +1 541 259 3901 (US)
or +44 191 268 5054 (UK)
entek.com