ACTIV-inst - AMQ Solutions
Transcription
ACTIV-inst - AMQ Solutions
instructionGUIDE ACTIV-1 sit-to-stand table Programming Memory Presets 1 On the LED screen attached to the front of the table, press the up or down arrow to set the worksurface to the desired height. 2 Press the “M” button followed by one of the preset number buttons (1, 2 or 3) on the LED screen. 3 The table is now programmed to automatically reset to this height whenever the preset number selected in Step 2 is pressed. For questions or support, please contact AMQ Customer Care at [email protected] or or (877) 801-0370. 915 Walsh Avenue / Santa Clara, CA 95050 (877) 801-0370 amqsolutions.com ! troubleshootingGUIDE ACTIV-1 sit-to-stand table ASR/RST Error Code 1 Reset the Base by holding the down arrow for 10-15 seconds until it reaches its lowest point and numbers appear on the handset. No Power 1 If there is no power in the Base, the Control Box may be damaged – contact us at [email protected] to order your replacement. E07/E08 Error Code: Legs Not Moving Uniformly 1 2 If the legs are not moving uniformly, or the Base goes up when the down arrow is pressed, reset the Base by holding the down arrow for 10-15 seconds until it reaches its lowest point and numbers appear on the handset. If the issue persists, swap the legs. (The legs with the pre-assembled screws should be facing the user.) If your issue persists, please contact AMQ Customer Care at [email protected] or (877) 801-0370. 915 Walsh Avenue / Santa Clara, CA 95050 (877) 801-0370 amqsolutions.com