atmospherix A20 concealed audio

Transcription

atmospherix A20 concealed audio
atmospherix A20 concealed audio
• in-ceiling speaker
• angled baffle for directed sound
• thin bezel magnetic grille
• fully enclosed backbox
The Atmospherix A20 are designed to project sound toward your primary
listening area. Dialogue will become more articulate, music will have
better definition and surround effects will become more involving and
realistic. The ‘A20’ variant of this awarded speaker houses a 20 degree
angled baffle, upgraded ring radiator tweeter and thin bezel magnetic
grille.
The Atmospherix A20 uses a130mm (5”) bass driver matched with a
26mm (1”) ring radiator tweeter, housed in a fully enclosed backbox for
in-ceiling installation. The enclosed design maximises and controls bass
response while keeping out dust and other ceiling inhabitants.
The A20’s ablility to direct more sound towards the listener results in
less sound reflecting off walls and other surfaces in the room, creating a
clearer, more three dimensional soundstage. Atmospherix A20 are ideal
for an out of sight home theatre experience, performing as main fronts or
side and rear surrounds in a conventional 5.1 or 7.1 configuration, or as
ceiling effect speakers in a Dolby® Atmos™ setup.
The A20 may also be used for background music applications where
the speakers must be placed near a side wall for aesthetic or structural
reasons. In this application the A20 can be aimed to project the sound
towards the centre of the room.
specifications
atmospherix A20
Frequency Range
Power Handling
Sensitivity
Impedance
Configuration
Bass Driver
45Hz - 40kHz (in room response)
20 - 120 Watts RMS recommended amplifier power
90dB SPL - 2.83V at 1m
Nominal 6 Ohms (Minimum 3.9 Ohms)
2-way
Cast aluminium basket with a 130mm (5”) doped
curvilinear paper cone. 25mm (1”) voice coil wound on
high powered aluminium former with copper shorting ring.
Vented and double magnet shielded
26mm (1”) ring radiator tweeter
High Frequency
Driver
Enclosure Type
Vent Location
Dimensions
Cutout Diameter
Weight
Bass Reflex
Front
295mm diameter x 193mm mounting depth
247mm recommended
2.5kg
Krix Loudspeakers Pty Ltd
14 Chapman Road Hackham SA 5163 Australia
T. 1300 00 KRIX or 08 8384 3433
W. www.krix.com E. [email protected]
O 295
top view
4
193
mounting depth
A
245
side view
O4.5
maximum wire gauge 10AWG
DETAIL A
Krix Loudspeakers Pty Ltd
14 Chapman Road Hackham SA 5163 Australia
T. 1300 00 KRIX or 08 8384 3433
W. www.krix.com E. [email protected]
Doc Rev 1