docChangeLog Version 9.2.7
download 
Report Transcription
ChangeLog Version 9.2.7
ChangeLog Version 9.2.7 CFturbo® Software & Engineering GmbH ▪ www.cfturbo.com ID 5011 5028 5051 5067 Severity major crash minor minor Category Volute cutwater Functions Volute diffuser Main dimensions impeller Summary Simple cutwater fails for a double volute sample Functions dialog sometimes crashed while closing One curve of diffuser reference geometry is not visible Wrong unit is displayed in information for turbines 5068 5072 5094 5097 5099 5101 5110 5111 5115 5119 5122 crash minor tweak minor major minor minor feature feature crash minor Volute diffuser Functions Export General Finishing Mean lines General Performance prediction Batch mode 3D graphic Main dimensions impeller Last spiral section is incorrect for certain volutes depending on diffuser configuration. Selecting a wastewater function fails for impellers without defined blade properties 3D-Update done when export base file name edited Wrong calculation of meridional cross section area Removing the blades of a bladed stator leads to exceptions Wrong warning about overlapping blades appears for single bladed impeller Access denied exception when saving CFturbo project Mass flow is missing as another option for the performance prediction of compressors and pumps Add extension handler for batch file Exception in the Intel OpenGl graphics driver can occur when closing a project Machine Mach-Number not correctly calculated 5125 5126 5128 5129 tweak major minor minor 3D graphic Mean lines Volute cutwater Main dimensions impeller Progression dialog stays invisible if view is switched from 3D Model to Meridian and back Comparing impellers with and without splitters causes problems Creation of solid failed for a volute with simple cutwater due to tolerances between spiral and cutwater Shaft diameter calculation sometimes not updated 3D graphic Export Impellers are not rotating because the initial speed is 0 ANSYS TurboGrid: Diamonds are located on arbitrary places of meridional contour 5132 tweak 5176 minor 5170 major Export 5165 5158 5142 5120 5115 5103 Licensing Export Export ICEM Export Batch mode Export minor minor minor minor feature tweak ANSYS TurboGrid: Required splitter position rel. to main blade has to be considered when rotation is "counter clockwise" Virtual Machine VPC not detected ANSYS BladeGen: overlapping of shroud and last blade curves for open impellers ANSYS ICEM-CFD: Show warning on export dialog for internal volutes Trailing edge description missing in cft-geo file Add extension handler for batch file There is an unfitting warning in batch mode when exporting into 3D model based formats
