T25 24V Cash Drawer Specifications

T-Series 24V Cash Drawer Specification
The PowaPOS T-Series point-of-sale uses an industry standard 24V cash drawer port. This interface allows for direct cash drawer
control without requiring an added RS232 or USB interface board at the cash drawer.
The PowaPOS cash drawer port design is based on the Printer Cash Drawer Kick-out interface commonly used on Epson and other
printer models.
Cable Requirements
Existing 24V cash drawers that are connected to Epson, Citizen, Bixolon, Samsung, DH, Logic Controls, Okidata, and Olivetti receipt
printers can typically be reused without cable changes.
Existing 24V cash drawers that are connected to other printer models, or that are connected directly to POS terminals, may also be
reused but will require a cable change.
IMPORTANT: In either case, you must validate that your cable meets the specification below to connect from the T25
to the cash drawer.
The most common connector configuration is below.
- Connection
- Physical Interface at POS (printer kick-out model)
A standard RJ12 connector is used at the POS terminal. The pin-out is below.
Pin
Number
Signal Name
Direction
1 Not Connected
2
3
4
5
6
Drawer kick-out drive signal
1
Drawer open/close signal
+24V DC
Drawer kick-out drive signal
2
Signal Ground
Output Sink
Drive
Input
Output Sink
Drive
- Additional Reference
When used with APG cash drawers, please use the CD-005A cable reference from APG Cash Drawer
http://www.cashdrawer.com/wp-content/uploads/documents/M-43-015_RevA.pdf