SUPPORTS - Roofmart

THE ORIGINAL PIPEGUARD
The line of original PipeGuard Pipe Supports is designed to support
most common roof-top pipes from ½- to 5-inches in diameter.
Made from heavy duty EPDM, PipeGuard does not
require any tools for installation. Simply compress base
to “open” pipe clamp, and place it around the pipe.
Mini
Position in place and you’re finished.
Small
Tall Small
Large
SAFETY YELLOW PIPEGUARD
Clearly identify potential rooftop trip hazards with Safety Yellow PipeGuards. Made with 100% recycled
HDPE, they’re compatible with all common roof covers including PVC. The 10-inch long base won’t
damage roof covers and provides strength and stability for achieving superior load capacity.
A Low profile, 15⁄8-inch wide galvanized strut channel can be used
for single or multiple pipes. HDPE provides unmatched strength and
stability for superior load capacity. Accommodates standard strut clamps
(sold separately) Standard and height-adjustable models are available.
SUPPORTS
Now Available
DUCT SUPPORT
Thaler MERS-800A Duct Support consists of a pair of round, urethane insulated,
hollow section 6061-T6 aluminum supports with threaded leg assembly for
vertical adjustment and mounting plate, mounting hardware (adhesive type
supplied by others), and cross-bar carrier with EPDM end caps. Urethane insulated
STACK JACK flashings available in aluminum, copper, or stainless steel, with EPDM
Triple Pressure Grommet Seal at the top of the flashing and EPDM Base Seal,
complete the supports.
TERRACE LIGHTING ROOF SUPPORT
Thaler MERS-700 Terrace Lighting Roof Support consists of urethane insulated, epoxy primed, hollow
steel support and mounting plate, mounting hardware(adhesive type supplied by others), galvanized
threaded steel cap with round (diameter to suit) stainless steel lighting pole adapter stub. The centre
of the support is provided with a 1-1/2” (38 mm) hole to accommodate an electrical conduit (lighting
pole and conduit by others). Urethane insulated flashing, available in aluminum, copper, or stainless
steel, with EPDM Base Seal, completes the assembly.