DCS 6000 Digital Conference System DC 6120 P Conference

Transcription

DCS 6000 Digital Conference System DC 6120 P Conference
Data sheet no. 6.50b
DCS 6000
Digital Conference
System
DC 6120 P Conference Unit
• Configurable as a Chairman or Delegate unit
• XLR connector for DIS
microphone (lockable
with tool)
• Loudspeaker
• Easy exchangeable push
buttons to match local
language/functionality
• Mini Jack socket with
volume control for floor
signal
The DC 6120 P is a fully digital microcomputer controlled conference with
built in loudspeaker and XLR socket for
use with the DIS series of Gooseneck
Microphones.
The unit is easily configured for use
by either a delegate or a chairman and
the two push buttons can be exhanged
to match functionality or to match the
local language.
The unit is designed for portable use,
but can also be installed recessed in
a table.
Configured as Delegate Unit
Configured for use by a delegate the
unit features a Speak (Request) button for activating the microphone and
identifying the user to the system.
The second button is the Mute button.
As long as the button is activated the
delegates own microphone´is muted.
When muted the red light ring in the
connected gooseneck microphone will
be turned off.
•Lockable XLR plug for DIS GM 65xx
series gooseneck microphones
•Easy exchange of the push buttons
•“Speak”/"Request" push button for
activating/deactivating the microphone or joining the request queue
•“Request“ LED indicator
•“Speak“ LED indicator
•“Mute” push button for temporary
muting own microphone
•High quality loudspeaker with wide
frequency response
•Mini Jack with volume control for
floor language
•Push-To-Talk (Auto), FIFO, Manual
and VOX (Voice Activation) and
mixed operation modes (with SW
6000). VOX mode is CU Feature
License dependant.
•Microphone auto off
•T h r e e m i c r o p h o n e i n t e r r u p t
modes enabling “ping pong”
microphone operation
•Two DCS-LAN - connections (Single
cable "Loop Through") for CAT5 STP/
FTP cable• Digital audio transmission
•Free cable topology w. RP 6004
repeater
•Unique ID no. identification for automatic system initialization
microphones
•"Delegates Off" LED indicator
Microphones
The unit is designed for use with the
DIS range of Gooseneck Microphones
like the GM 6523 (40 cm) or the GM
6524 (50 cm).
The gooseneck microphone can be
fixed to the unit using a 2 mm hex key
(Allan tool/Umbraco tool). The locking
device is accessable through a hole
above the XLR socket.
Configured as Chairman Unit
When configured as chairman the two
push buttons changes the functionality:
•“Speak On/Off” push button with
chairman priority (chairman overrides
delegates)
•“Delegates Off" push button for
switching off all active delegate
DIS, Danish Interpretation Systems A/S, Vestre Teglgade 12, DK-2450 Copenhagen SV, Denmark, Tel.: +45 33 85 40 40, Fax: +45 33 85 40 41, e-mail: [email protected]
DCS 6000
Digital Conference
System
Technical
Specifications
Microphone Connection
Mic. Type: DIS Electret Cardioid
Connector Type: 3 pin female
XLR socket (lockable with tool)
DIS LAN Connections
Connector Type: RJ-45, screened
with auto-termination
Connection to DCS LAN using STF/
FTP Cat 5 or better cabling. The Cable
access is from rear with adequate
clearance for connection from beneath
the unit.
DC 6120 P Conference Unit
Headphone Connection
3.5 mm jack female stereo socket
for analogue output of
floor language
Frequency Response: 100-15 kHz
Temperature Range:
5 º - 40 º C
Electrical Characteristics
Power Requirements:
Supplied from CU 6005/6011
Power Consumption: 2.5 W (typical)
Loudspeaker
Frequency Range: 150 Hz - 15 kHz
Maximum Power: 3 W RMS
Audio Section
Frequency Response: 65 Hz - 16 kHz
THD: < 0.1%
S/N: > 90 dBA
Physical Characteristics
Dimensions (HxWxD):
61 x 150 x 168 mm
Weight: 650 g
Please refer to Data Sheet for CU 6011
for further specifications of the DCS 6000
system.
The DCS 6000 system conforms to all
relevant standards - e.g. IEC 914, ISO
4043, ISO 2603
Cut-out Dimensions
(recessed)
How to order
Product:
DC 6120 P Conference unit
Order no.:
15 12 59030
DC 6100 P Accessories
15 12 59801
One hex tool and 10 "All. Del. Off" buttons
GM 6523 Gooseneck Mic 40 cm 18 12 05714
GM 6524 Gooseneck Mic 50 cm 18 12 05716
Connection Cables
Product:
EC 6001-0.5 Cat5e, 0.5 m EC 6001-01 Cat5e, 1.0 m
EC 6001-02 Cat5e, 2.0 m
EC 6001-03 Cat5e, 3.0 m
EC 6001-05 Cat5e, 5.0 m
EC 6001-10 Cat5e, 10 m
EC 6001-20 Cat5e, 20 m
EC 6001-30 Cat5e, 30 m
EC 6001-50 Cat5e, 50 m
Order no.:
10 03 22500
10 03 23101
10 03 23201
10 03 23301
10 03 23501
10 03 24102
10 03 24202
10 03 24302
10 03 24502
DIS, Danish Interpretation Systems A/S, Vestre Teglgade 12, DK-2450 Copenhagen SV, Denmark, Tel.: +45 33 85 40 40, Fax: +45 33 85 40 41, e-mail: [email protected]