i Net2+ - Argon Audio

Transcription

i Net2+ - Argon Audio
03-09-14
List of FW 4.0.1
Changes
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de
LIST OF FW 4.0.1 CHANGES
All Routers
Added blocking of incoming traffic on all non-selected backup routes
Change of Backup routes configuration. All unused routes are put into chain Block by
default, so unused routes are banned.
Removed unnecessary erasing of FLASH during firmware update
This speeds up firmware upgrade time. Some routers need approximately half of the
time needed before (3 minutes to 1.5 minutes), some routers need just shorter time
(20 seconds shorter).
All Routers Apart from ER75i and UR5
Added library libm.so
C math library libm.so was added. Functions in this library provide common
elementary mathematical functions and floating point environment routines defined by
System V, ANSI C, POSIX, and so on. Additional functions in this library provide
extended support for handling floating point exceptions.
Fixed NAT traversal support that was mistakenly removed from Openswan
Openswan is an IPsec implementation for Linux. It has support for NAT Traversal
(techniques that establish and maintain Internet protocol connections traversing
network address translation (NAT) gateways).
Upgraded PPP to version 2.4.6
Linux implementation of PPP (Point-to-Point Protocol – data link protocol used to
establish a direct connection between two nodes) was upgraded to version 2.4.6.
All v2 Routers
Added support of connecting to WiFi network with hidden SSID
03-09-14
Routers can connect to WiFi network with hidden SSID. Hiding the network’s SSID
(service set identifier) enhances its security. SSID has to be set before explicitly.
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de
LIST OF FW 4.0.1 CHANGES
Added filesystem devtmpfs
Devtmpfs is a virtual file system containing informations about connected devices.
Devtmpfs lets the kernel create a tmpfs instance called devtmpfs very early at kernel
initialization, before any driver-core device is registered. Every device with
a major/minor will provide a device node in devtmpfs.
Set SSH login timeout to 1 minute and idle timeout to 10 minutes
Login to SSH (Secure Shell – a cryptographic network protocol for secure data
communication) is now more secure. SSH protocol itself contains no timeouts for
login and idle logout. With added timeouts user has to write down a password during
1 minute and if he is 10 minutes idle, he is logged out automatically.
Fixed initialization of timer for MACB controller
Timer for MACB controller (controller for Ethernet interface) is working properly.
Fixed receiving data from serial line
Expansion port XC-232 in PORT2 didn’t send data with length 8 B and multiplies.
Problem caused by bad “fifosize” value is fixed and XC-232 in PORT2 is working
properly.
All v2 Routers Apart from UR5i v2L
Fixed function of XC-ETH in second expansion slot
XC-ETH is now working in PORT2 even if eth0 is unplugged.
All Routers Apart from XR5i, XR5i v2 and
Spectre RT
Fixed invalid value of SNMP OID mobileDisconnect
03-09-14
Value of OID (object identifier) of mobileDisconnect variable in SNMP (Simple
Network Management Protocol) was fixed.
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de
LIST OF FW 4.0.1 CHANGES
All Routers Apart from ER75i, UR5, XR5i,
XR5i v2 and Spectre RT
Added support of PPPoE
Routers now support Point-to-Point Protocol over Ethernet. There’s new item PPPoE
in the administration menu. PPPoE encapsulates PPP communication inside Ethernet
frames.
UR5, UR5i, UR5i v2, LR77 v2, Bivias v2HC and
Bivias v2LC
Fixed reading of SMS when SIM card is full
Fixed by different reading out method. The new method reads out one after one SMS.
It was a bug of wireless module supplier – module rebooted itself after executing
some AT commands if there was 40+ SMS.
UR5, UR5 v2, UR5i v2, UR5i v2L
Fixed reading of operator name
If operator name stored on SIM card was corrupted, it was wrongly displayed in the
web interface. Operator name is now read from the module instead of the SIM card.
Fixed return to automatic network type selection
03-09-14
There was a problem with restoration of automatic network type selection. In
administration interface user chose e.g. UMTS network type. Then he chose back the
automatic network type but this option wasn’t enforced. Automatic network type
selection now works properly.
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de
LIST OF FW 4.0.1 CHANGES
XR5i, XR5i v2 and Spectre RT
Fixed checking of PPPoE backup route
There was a problem at PPPoE (Point-to-Point Protocol over Ethernet) backup route
configuration. Configuration of Ping IP Address in router administration interface does
now proper change.
Spectre 3G, Spectre LTE-AT and
Spectre LTE-VZ
Upgraded driver for Gobi 3000/4000 modules to version S2.18N2.24
Driver for Gobi 3000/4000 modules was upgraded to version S2.18N2.24
LR77 v2, Spectre LTE-AT and Bivias v2LC
Fixed registration to LTE network
There was a problem of AT commands order at APN (Access Point Name) setup
when registering to LTE network. This was not well documented at LTE
specifications. The change of AT commands order made the correction of
registration.
LR77 v2, Bivias v2HC and Bivias v2LC
Added logging of network connection failure reason
03-09-14
Feature of routers with mobile USB interface devices (usb0). On ppp0 connections
users get a very detailed error log. Now they can get detailed error log with usb0
connections also. Missing informations in system log can be added by calling AT
command “AT+CEER”.
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de
LIST OF FW 4.0.1 CHANGES
Bivias v2HC and Bivias v2LC
Fixed issue with dynamic allocation of pppX interfaces
There was a problem with incorrect allocation of pppX interfaces to particular
modules. This is now working properly – every module gets the right interface.
LR77 v2 and Bivias v2LC
Added support of Sierra Wireless MC7304 modules
Routers now support Sierra Wireless MC7304 modules.
ER75i and UR5
Increased maximal length of shell variable to 8 KB
Long keys in v1 routers caused error messages. Shell variable length was increased
to 8 KB.
UR5i v2
Added support of DirectIP connection for Sierra Wireless MC8705 modules
Sierra DirectIP connection is used instead of PPP (Point-to-Point Protocol)
connection in previous version.
UR5i v2L
Fixed detection of WiFi module
03-09-14
Hardware detection of WiFi expansion board fixed.
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de
LIST OF FW 4.0.1 CHANGES
LR77 v2
Added support of Cinterion PLS8 modules
Routers now support Cinterion PLS8 modules.
Spectre LTE-VZ
Fixed reading SMS from MC7750 module
03-09-14
SMS reading from MC7750 module is working properly.
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de