Sandstone, Limestone, Concrete highly absorbent materials

Comments

Transcription

Sandstone, Limestone, Concrete highly absorbent materials
Sandstone, Limestone, Concrete
highly absorbent materials
1. Pretreatment* before installation / grouting
Finalit No. 21S Pores Filler / Pretreatment with basic protection
Finalit No. 21S
1l up to 15m2
Dilutable max. 1:2 with
water. Pre-treat
all sides.
Laying /grouting.
Cleaning
(see step 2
Basic Cleaning)
Impregnation
(see step 3
Impregnation)
* If you do not want to treat all sides, we urgently recommend to apply Finalit No. 21S
before Finalit No. 20 Hot Impregnation in order to protect your surfaces.
2. Basic Cleaning when required
Finalit No. 9 Lime and Cement Bloom Remover + Finalit No. 1 Intensive Cleaner (Neutralisation)
1:20
1:10
Finalit No. 9+1
1l No. 9 up to 30m2
1l No. 1 up to 60m2
Dilute Finalit No. 9 with
water in a 1:10 ratio
Brush in Finalit No. 9
using a hand-held pad
holder and a brown pad,
or using a cleaning
machine.
Allow to stand for about
15 min, then rinse
thoroughly with water.
Dirty water must be
removed.
Dilute Finalit No.1 with
water in a 1:20 ratio
Brush in using a handheld pad holder and a
brown pad, or using
a cleaning machine.
Allow to stand for about
15 min, then rinse
thoroughly with water.
Dirty water must be
removed.
3. Long-term Protection
Finalit No. 20 Hot Impregnation / Long-term Protection
Finalit No. 20
1l up to 40m2
Heat Finalit No. 20 in a
water bath to 50-70°C.
Empty Finalit No. 20
into a container, dip a
yellow woolly washer
into the bucket.
Apply the impregnation
with 1 or 2 swipes,
wipe off the excess immediately after application.
Allow to dry for about
1 hour before walking
on the floor.
Long-term protection
from spotting and soiling.
4. Daily Cleaning
Finalit Nr. 40 Citrus Scent Cleaner for All Surfaces
Finalit No. 40
1l up to 1000m2
Measure Finalit No. 40 out
into the screw-top cap
Dilute the measured-out
amount with water.
1 cap per 5-litre bucket
Dip brush or cloth into
bucket and apply
Use a wet vac to draw off
the dirty water.
Done - your floor is clean
and disinfected!
Important Tip for Daily Cleaning!
With impregnated floors, water cannot penetrate into the floor or joints. It is therefore particularly important that excess water is
removed with a wet vac. If no wet vac is available, wipe with a squeegee or dry off afterwards with a dry cloth.
www.finalit.com

Similar documents