Manual instruction - Heating bench COMODO

MANUAL INSTRUCTION
1. C2 element screw with C1 element using S1 screws.
(Allen keys are needed).
2. C3 element slide from the top and attach to the sides
using S2 screws.
C3
C1
S2
C2
S1
S1 - M6x20
S2 - M4x8
STANDARD COMPONENTS:
•
Cover made of steel galvanised with zink-magnesium layer, RAL 7047 and RAL 9005 powder-coated
•
Unit sides are made of tempered glass
•
Coil - copper-pipe with aluminium fins water side heat exchanger,
•
Air went valve,
•
TRV (thermostatic valve),
•
Sitting boards that is made from coated oak wood
•
Connections ET3/4˝
ADDITIONAL EQUIPMENT:
•
Any RAL colour of the casing
•
Other wood materials and finishes concerning sitting bench convector are available on demand.
3. W1 element put between the sides and check if the holes
are on a correct place. Secure by S3 screws and N1 nuts
using P1 pads.
S3
W1
P1
N1
Name
W1
S3
P1
N1
S3 - M8x50
P1 - Pad M8
N1 - Nut M8
Quantity
1
4
4
4
453
453
103
420
130
L-260
L
4. Put C4 element and check if the holes are on a correct place.
5. Adjust the D1 board and screw it from the bottom using S4 screws.
Repeat for other boards.
6. Put the bench in the final destination, secure to the floor using K1
dowels and S5 screws.
7. Perform a hydraulic connection to the ¾" pipe connections.
8. Put the C5 blanding panel.
D2
D1
C4
S5
P1
S4 - M8x20
C5
S5 - Srew
K1
S4
K1 - Dowel
P1 - Pad M8
Name
C4
D1
D2
S4
S5
K1
P1
We have tried to make this COMODO manual istallation simple and intuitive.
But if you need help - contact us.
VERANO, ul. Vetterów 7a, 20-277 Lublin, POLAND
tel. +48 81 44 08 330, tel. +48 515 166 103, fax. +48 81 44 08 333
Quantity
2
2
1
6
4
4
4