Half Top Net, Jeep JK 4Dr - Motion-Tek

Jeep JK Unlimited 2007 - Present
Half Top Net
Installation Instructions
Contents include one Half Top Net and one package of extra strap keepers.


The Half Top Net is easier to install with the hard top removed or the soft top down or removed.
The Motion-Tek label on the Half Top Net locates in the lower right rear of the jeep.
Half Top Net, Jeep JK 4Dr
Page 1
Front Strap
Second, Third and Fourth
Straps
Strap with J-Hook - Used for
“quick-cargo” loading system.
Motion-Tek Label - Toward
lower right rear of jeep.
Strap with flat hook - Used for
“quick-cargo” loading system.
Installing Strap into Cam Buckle - Route the strap as
indicated in each instruction set. Depress lever on cam
buckle, which creates an open slot in the buckle. Push
pointed end of strap through open slot from the back side
of the buckle (opposite side of lever) . Pull strap through
and release lever.
(Do not tighten straps until all are attached.)
(Caution: Route straps so they do NOT wrap
around or restrict use of seat belts.)
1. Installing Half Top Net - Place net on top of Jeep roll
2. Wrap the second, third and fourth straps on both sides
cage cross bars with front straps toward front of vehicle.
around the roll cage and through the cam buckle as
Align front of net with front cross bar of Jeep roll cage.
shown above.
Route front strap off the side of roll cage and toward the
front around the inside of the vertical post. Then route up
on the outside of the front roll cage bar and through the
cam buckle as shown above. Repeat for front strap on
opposite side.
Page 2
3. Route the J-hook strap around the roll cage and hook
back into the ring it is attached too. (Caution: Do Not restrict use of seat belts.)
4. Route the flat hook toward the side of the Jeep and
hook under the edge of the Jeep body in location shown
above.
5. After all straps have been attached to the roll cage,
tighten the straps a little at a time starting with the front
straps and working toward the rear. The side straps
should angle slightly toward the rear to insure the net is
pulled tight. Make sure the front row of the net lies just
behind the hard top bolt holes in the forward cross bar
and the net is centered in the roll cage.
6. After the final adjustments are made and the net is tight
and centered, slide each strap end into the strap keeper
provided. The strap keeper should be positioned near the
end of the strap to secure as shown above.
The hard and / or soft top may be installed with the Jeep JK Unlimited Half Top Net attached to the roll cage.
The J-hook strap and the strap above it may need to be detached from the roll cage to eliminate soft top frame
interference when putting the soft top up and down. They should be reattached after the soft top is in its final
position, either up or down. The Half Top Net does not interfere with soft top window installation or removal.
The J-hooks are part of the Quick Cargo System. See Quick Cargo System Instructions for operation.
JKU HTN - Rev. 1
Page 3