Pipemaster Flyer Front (no contact) 9_3_08

Fitting Both Ends At One Time
1
2
Using two stubs of pipe and a length of angle,
determine the location of the pipe to be
installed. Tack weld the stubs and draw center
lines on the two stubs and the pipe to be cut.
4
3
Slide the PipeMaster on one of the stubs with the
tool centerline aligned with the pipe centerline.
Adjust the pins to fit the joint and mark the
location of the plastic housing on the stub.
5
Slide the PipeMaster on the opposite stub with
the centerlines aligned. Adjust the pins to fit the
joint. Measure the distance from the housing to
the mark on the first stub.
Part #
P-100
P-125
P-150
P-200
P-250
P-300
P-400
P-500
P-600
P-800
P-1000
P-1200
Nominal Pipe
Size (I.D)
1"
1¼"
1½"
2"
2½"
3"
4"
5"
6"
8"
10"
12"
6
Transfer the distance measured in step 4 to the
pipe to be cut. Slide the PipeMaster on the pipe
at this location, align the centerlines and mark
the cut line.
Outside Diameter (O.D.)
Inches
Millimeters
33.33
15⁄16”
41.28
15⁄8”
47.63
17⁄8”
60.33
23⁄8”
73.03
27⁄8”
88.90
3½”
114.30
4½”
141.29
59⁄16”
168.28
65⁄8”
219.08
85⁄8”
273.05
10¾”
323.85
12¾”
Sizes available as of 9/3/08 - For additional sizes call (360) 668-3291
Part #
P-T050
P-T0625
P-T075
P-T0875
P-T100
P-T1125
P-T125
P-T1375
P-T150
P-T175
P-T200
P-T250
P-T2625
P-T275
Tips:
• When making patterns keep the pins as short as possible.
• When fitting both ends always use a centerline.
• For difficult patterns, use your fingers to adjust the pins.
Slide the PipeMaster on the pipe to be cut. Align
the tool and pipe centerlines. Mark the location
of the housing on the pipe and trace the shape
of the cut line.
P-T300
P-T325
P-T375
P-T400
P-T425
Remove stubs and grind tack welds. Check the
final fit and weld in place.
Outside Diameter (O.D.)
Inches
Millimeters
12.70
½"
15.87
5⁄8"
19.05
¾"
22.23
7⁄8"
25.40
1"
28.58
11⁄8"
31.75
1¼"
34.93
13⁄8"
38.10
1½"
44.45
1¾"
50.80
2"
63.50
2½"
66.68
25⁄8"
69.85
2¾"
76.20
3"
82.55
3¼"
95.25
3¾"
101.60
4"
107.95
4¼"