RWA-Universal Mirror Arm Owners Manual-(22-Feb-08)-Rev-D0

S.I. Caddy Rack
Assembly Instructions
S.I. CADDY RACK HARDWARE
TOOLS REQUIRED
PARTS
A
x4
A
B
x4
C
x2
MEDALLION
x1
D
x2
RE
D
TH
RE
A
BACKING
PLATE
x1
DL
OC
KE
R
TINES
x2
3/16" Allen Key
5/32" Allen Key
3/32" Allen Key
***BOARD RACK BUNGEE CORD AND CLIP NOT ILLUSTRATED FOR IMAGE CLARITY***
***UNIVERSAL CLAMP SOLD SEPARATELY***
Apply RED Loctite to 4
(A) bolts and assemble
the tines to the backing
plate.
Left Tine
B
Test fit the clamp to your tower and rotate the rotational disc
so that the rack will be as close to horizontal as possible
when assembled.
3/16"
C
E
Right Tine
Depending on the tubing
diameter of your tower, place
the proper size plastic insert
into the clamp, 1.9’’ or 2.375’’.
(1.6”,2.0” and 2.5” are
available upon request).
Apply RED Loctite to 4 (B) bolts and sssemble the backing
plate to the universal clamp.
D
F
Tighten the clamp around
the tubing. Apply RED
Loctite to the clamp bolts
and fasten the clamp into
position on the tube. Apply
RED Loctite to the clamp
set screw and tighten.
3/16"
THREADLOCKER
A
x4
THREADLOCKER
Horizontal
Apply RED Loctite to both (C) locking pins and insert into the
back of the medallion.
5/32"
C
x2
3/32"
THREADLOCKER
B
x4
THREADLOCKER
Alternate View
Rev. 24-Feb-11
Pg. 1/2
G
Position Medallion on backing plate using the locking pins as
guides.
H
Apply RED Loctite to both (D) set screws, hold the
medallion in place and insert the 2 set screws through
the top of the backing plate.
D
x2
3/32"
THREADLOCKER
TOP VIEW
CAUTION
When attaching or removing the board rack strap be sure you have a good grip on the clip. Clip
and strap may be under tension and could cause injury.
Always remove all equipment from rack when boat is being transported on a trailer.
www.roswellwakeair.com
If you have any questions please call : 1-780-962-0868
Rev. 24-Feb-11
Pg. 2/2