How to Upgrade the MGI3 card

Transcription

How to Upgrade the MGI3 card
How to Upgrade
the MGI3 card
MGI3 Cards

There are two different kinds of MGI3 card




The software is Not Compatible between the OSxxx & Osxxxx
MGI cards
How do you know what software is for which card?



MGI3 for OS100, OS500
MGI3 for OS7100, OS7200, OS7400
MGI3 SW for OSxxx (mgi3.xxx) (dsp.xxx)
MGI3 SW for OS7xxx (mgi.xxx) (dsp.xxx)
Upgrade procedure is the same for both types of cards but Login
details are different.
Upgrading the MGI3 card

What you will need





PC
FTP client SW e.g. FTP Commander (freeware)
MGI3 card installed into relevant phone system and booted up.
MGI3 SW downloaded onto your PC
Upgrading
1.
Configure an IP address onto the MGI card if none exists
•
•
2.
MMC831 / IT 2.2.2 and restart card for setting to be set
Make sure you can ping the IP address of the MGI card from your PC
Install and Run FTP client SW on your PC
Upgrading the MGI3 card
3.
Browse to the folder on your PC where you have saved the MGI3 SW
MGI SW on your PC
Upgrading the MGI3 card
4.
Select New Server and enter the IP address of the MGI card and Login details to
connect to the MGI card & Save
Login details for MGI card
IP address of MGI card
MGI3 for OS7xxx
Username: mgi
Password: mgi2550
MGI3 for OSxxx
Username: mgi3
Password: mgi33
Upgrading the MGI3 card
Your newly created server will now appear in the Server List
5. Double click the server to connect to the MGI card
Once connected to the MGI card you should see some files on the MGI card
Upgrading the MGI3 card
6.
Select all the MGI files on your PC and select Upload to FTP Server
The files will now show on the FTP Server i.e. MGI card
Upload Files to FTP Server
Upgrading the MGI3 card
7.
Select Disconnect
Upgrading the MGI3 card
8.
Open a command prompt and enter:

9.
Telnet (ipaddressofmgicard) and Enter
Enter the Login details for Username & Password
Upgrading the MGI3 card
10.
Enter LS and press enter
You should now see the files you have uploaded onto the MGI card, if not perform
steps 5 -7 again
Upgrading the MGI3 card
11.
If all the files are present as on the previous page then enter the following
commands.
MGI3 for OS7xxx



siglo mgi.* and enter (wait for command prompt)
siglo dsp.* and enter (wait for command prompt)
sigboot (MGI card will reboot)
MGI3 for OSxxx



siglo mgi3.* and enter (wait for command prompt)
siglo dsp.* and enter (wait for command prompt)
sigboot (MGI card will reboot)
Once the MGI card has booted backup confirm the SW level in
MMC 727 / IT 2.2.0