gv650 front fender how to.indd
Transcription
gv650 front fender how to.indd
Custom GV650 Front Fender What you need to start with is a GV650 under-bracing for the stock front fender. Not the chrome part or the plastic part, but the metal mounting bracket that hides under the stock GV650 front fender. Then you will need a Hyosung GT series front fender (GT250 and GT650 fenders are the same). You will also need 4 small bolts and nuts and a drill. To start, mount the bracing on the bike. Use the large 6mm bolts under the calipers and only the 2 small lower mounting bolts on the front of the brace. Then slide the GT fender over the brace and mark the 2 front GT mounting holes on the brace. Remove the GT fender and the brace, then drill the holes marked on the brace. Use the new nuts and bolts to bolt the GT fender to the brace, thru the GT stock mounting holes. Then reinstall the fender using the 2 large bolts under thre caliper and the 2 front lower bolts on the fender brace. Stock GT fender mounting points used. Locations drilled into GV650 brace. Finished fender with bolts fiberglassed over for smooth appearance Stock GV650 mounting bolts used This material is the sole work of the AmishCrackDealer. Any reproduction or re-distribution without express written consent of the AmishCrackDealer will result in the torture of your relatives and the dissemination of illicit material depicting you committing illegal acts with barnyard animals.