DIGITAL TV ANTENNA?
Transcription
DIGITAL TV ANTENNA?
5 REASONS TO UPGRADE TO A digital TV ANTENNA These guides will assist you in completing your antenna installation WHY UPGRADE TO A 1. digital switch-over & Digital antennas DIGITAL TV ANTENNA? Digital TV channels have shifted with respect to the traditional analogue channels, changing the range with which an antenna must perform. New “Digital” antennas are designed to reflect this shift; taking out what is not needed, and maintaining was is required. Cable Termination 2. digital design Our new designs are matched to the shift in digital TV broadcast signals in a way which allows for a smaller, lighter size, offering improved performance with more precise signal collection and gain. Scan the following codes for complete information (PDF) 3. robust Build Not only have we redesigned for the channel shift, we have also redesigned the mechanical aspect; offering a rugged design, with enlarged, reinforced elements, complemented by a strengthened support bracket system. 4. sharp finish In addition to the new electrical and mechanical properties, we have taken steps to refine the overall finish of the new antennas, offering an enduring powder coated finish for all elements and boom, UV stabilised, hard wearing plastics, and an integrated weatherproof balun design. 5. research and design Antsig_CPPOS11.indd 1 ANTSIG is proudly produced by Arlec Australia Arlec Australia Address: Mail: Phone: Fax: Building 3, 31-41 Joseph Street Blackburn North, Victoria, Australia 3130 PO BOX 1065, Blackburn North, Victoria 3130, Australia +613 9982 5000 +613 9982 5199 Sales/Support Phone: +613 9982 5111 Fax: 1300 360 650 (toll free) ustomer Service: [email protected] C Tech Support [email protected] © Arlec Australia 2013 CPPOS11 Our R&D lab, located in Melbourne, Australia, includes a fully functioning anechoic test chamber. This has allowed us to refine the capabilities of the new design, give us the capacity for more stringent quality control practices and allowing you to take advantage of the switch to digital broadcasting. Antenna Installation 25/10/13 12:34 PM improving antenna Performance 1. Digital Designed For Digital Reception Meets the demands of digital TV reception with more precise gain transfer while rejecting all unwanted noise 2. POWDER COATED Elements All elements are powder coated aluminium with hard wearing, refined finish for enduring environmental extremes 3. heavy duty » Antenna Range Bracket Construction Robust, heavy duty bracket design for extended life and improved durability All elements are reinforced at the pivot point for superior strength and enhanced ‘sag’ prevention DIGITAL HD TV Antenna Designed for digital TV reception Receives all 3D TV broadcast signals Receives full high definition TV broadcasts, for a perfect picture Will receive DAB+ digital radio signals, for clear, perfect sound VHF UHF CHANNELS 6 - 12 4. Weather Proof Design & h c Resear Testing Antsigg’san Anec horices your usin mber ensu designed Cha antenna is andards new ustralian stital Signal to A precise Dig for ection. Coll 5. machine pressed Balun Design Front Elements Balun includes a weather proof design, Front elements have been machine pressed preventing a build up of corrosion and grime into the boom for sturdiness thus preventing the usual decline in connection of the balun over time Enlarged element diameter for tough, hard wearing durability State-of-the-art Integrated balun design for tight and secure connection Strengthened integrated element design PRIME RECEPTION AA1100 MEDIUM RECEPTION AA1200 FRINGE RECEPTION AA1300 CHANNELS 28 - 38 » Reception Areas Your antenna selection is determined by the type and distance to the local transmitter. These regions are defined by Prime, Medium or Fringe, shown as green, yellow and red respectively. Refer to your local store map. TRANSMITTER PRIME MEDIUM FRINGE Testing Equipment Antsig_CPPOS11.indd 2 25/10/13 12:35 PM