HEA TER TEMPLA TE PROP END

CUT OUT
THE LITTLE "O" IN THE CORNERS REPRESENT A 1/8" HOLE. IF YOU DRILL THE HOLES BEFORE CUTTING,
YOU CAN CUT TO THEM AND IT WILL HELP PREVENT CRACKING IN THOSE SPOTS!
ONCE YOU HAVE THE "PIPE" CUT AND TABS BENT, TRIAL-FIT TO YOUR COWLING .... YOU MAY NEED TO
TRIM THE TABS SLIGHTLY TO FIT.
DOTTED LINES ARE FOLDS.
SOLID LINES ARE CUTS.
FOLD OUT 90 DEGREES
CUT OUT
SELECT "PORTRAIT"
o
CUT OUT
FOLD OUT MORE THAN 90 DEGREES
o
o
FOLD
OUT
90
Degrees
PRINTER SETTINGS:
FOLD
OUT
90
Degrees
o
PRINT CHECK - Confirm this distance equals 11 3/8 inches
THIS TEMPLATE IS SHORTER THAN THE (16 1/4") STAINLESS TUBE!
MAKE SURE YOU PLACE IT AT THE PROP END (
) FOR MARKING AND CUTTING!
PUT THE PIPE SEAM AT OR NEAR THE BOTTOM SIDE OF THE HEATER, WHERE IT WILL NOT BE VISIBLE,
AND WILL NOT INTERFERE WITH THE INSTALLATION OF THE DAMPER BOLT.
HEATER TEMPLATE
MAKE SURE IT IS
2 TO 2 1/16 INCHES
TO END OF PIPE.
MAKE SURE IT IS
2 TO 2 1/16 INCHES
TO END OF PIPE.
PROP
END
SELECT 8.5 x 14" (LEGAL)
o
DISABLE "FIT TO PAGE" .
USE TWO SHEETS
8.5 X 14 INCH PAPER (LEGAL)
IF THIS PRINTS ON TWO
PAGES, SIMPLY TAPE THE
TWO PAGES TOGETHER
AND TRIM OFF EXCESS.