twp® ws series twp® ws series

TWP® WS SERIES
AVAILABLE IN FOUR RICH COLORS.
The TWP® WS colors contain special UV
absorbing pigments which inhibit unsightly
graying caused by the sun. The products are
semitransparent and allow wood grain and
color to show through.*
* Apply product to small section of surface to be coated to determine
acceptability of color.
For additional information, contact
your AMTECO sales representative or
call us at 1-800-969-4811
PO Box 9 • 1100 Jefferson Dr.
Pacific, Missouri 63069
TWP® WS SERIES
WS01 Cedartone
Your Local TWP® Dealer
LOWC
VO ER
T
WA NUP
A
CLE
WS02 Redwood
WS03 Dark Oak
WS20 Pecan
Made in the USA
why just stain...
...WHEN YOU CAN PROTECT!
For more information:
www.amteco.com
TWP® is a registered trademark of AMTECO Inc.
Protect and beautify with the
flexibility and convenience
of water!
WATER-BASED
TWP® WS is a unique combination of chemicals that
enhances the natural beauty and warmth of wood.
TWP® WS penetrates deeply into wood without surface
film build, highlighting existing grain patterns with
amazing clarity and warmth. TWP® WS contains water
repellents which inhibit the damage caused to wood
by water absorption and contains carefully selected
mildewcides that inhibit the growth of mildew on the
surface of the stain.
TWP® WS SERIES
TWP® WS SERIES
features and benefits
APPLICATION PROCESS AND
RECOMMENDED INSTRUCTIONS
WATER REPELLENT
• Mix thoroughly before/occasionally during use
Resists warping, cracking and splitting. Prevents freeze
damage in colder climates.
• Can be applied using brush, applicator pad,
roller, or low pressure sprayer
STOPS U.V. DAMAGE
• Apply initial coat at 300-400 sq ft/gal
U.V. absorbing pigments prevent unsightly wood graying, darkening and fading.
MILDEW RESISTANT
Inhibits growth of mold and mildew on surface preventing premature discoloration. Decks, log homes, fences
and wood siding stay new looking longer.
EASY TO APPLY AND MAINTAIN
Penetrating, long lasting formula is easy to apply and
easy to maintain.
PERFECT FOR
exterior wood applications
including decks, siding, log homes,
fences, shutters, fascia and furniture.
• Coat boards lengthwise maintaining a wet edge
to avoid lap marks; only apply as much as wood
can absorb
• If spraying, back brush to work material uniformly
into the wood
• Allow material to penetrate 10-15 minutes and
then apply a second coat at 400-500 sq ft/gal
• Typically a two coat application is adequate, but
wood porosity may dictate the number needed
• Remove any liquid material that remains on the
wood surface 10-15 minutes after the application of the final coat with a dry brush, roller, applicator pad or cloth
• Do not thin
• Dry time will vary greatly depending on the
amount absorbed, wood species and weather
conditions, but is typically 24-48 hours.
for more information: call 1-800-969-4811 or visit www.amteco.com