electrolysis hair remo
Transcription
electrolysis hair remo
8 2 9 CONDUCT IV E G E L 1 0 Fault/Cause remedy Amber treatment light does not stay/comeon and console bleeps. Good contact with the hair is not being maintained or your finger is not touching tweezer button. Check tweezers are connected The contact with the hair or tweezer button has been lost. If the contact is not re-established within three seconds the treatment timer will assume you have moved onto a new hair and restart the treatment from the beginning. Ensure you are using gel. Grasp hair at skin level. instructions 7 Problem HAIR REMOVER ™ 6 TRO uBLEsHO O TING ELECTROLYSIS YO U R E L E C T R O LY S I S H A I R R E M OV E R 5 4 B AT T ER Y 9V P P 3 © The Dezac Group professional range BODY CARE 3 1. Console 6. Wand output socket 2. PowerON/OFFbutton 7. Power adapter socket ! (optional extra available from the Customer Careline) 3. Treatment indicator (AMBER) 8. Tweezer Socket 4. Control dial 9. Tweezers 5. Treatment complete indicator(GREEN) 10. Conductive gel 11.9VPP3Battery The amber light has gone out and the console is bleeping. Grasp hair at skin level. The console is bleeping and the power light is flashing. Console left on and not used. Turn the console off. Console is bleeping constantly. Low Battery. Replace battery. The hair is difficult to remove. More than a single treatment is required to kill this hair. If there is a lot of resistance an additional treatment or longer treatment time of the same hair may be required Hair regrows. It is not always possible to kill all of the papilla cells in a single treatment. Repeat the treatment when the hair grows back. © The Dezac Group T I PS • TheElectrolysisHairRemoverwillnotoperateifitcannot detect the conductive gel. • IfthepowerON/OFFbuttonisflashingthisindicatesthe battery power is low and it needs replacing. • Alwaysusethecorrecttypeofbattery(9VPP3). The use of a good quality, leak-proof alkaline battery is recommended. • Iftheunitisleftunusedforalongperiodoftime,remove the battery or unplug from the mains. Redness of skin after treatment. Use a longer treatment time. This is quite normal, you may wish to apply an antiseptic cream, however the redness should fade within one or two hours. • TheElectrolysisHairRemovermayalsobeusedwitha power adapter, which plugs into the adapter socket on the side. To order please call the Customer Careline. Using micro current technology the Electrolysis Hair Remover destroys the hair root and papilla to prevent future hair growth. The micro current changes the pH in the hair follicle to alkaline which then starts to attack the hair root and papilla cells (it is these cells which are responsible for hair growth). This action continues for sometime after the treatment is complete and the hair has been removed. It is not always possible to kill all of the papilla cells in a single treatment and in these situations the hair may regrow. If it does regrow it is generally much finer and lighter than previously. Successive treatments will kill the papilla cells giving a permanent result. You may use your normal epilation methods in between treatments. © The Dezac Group G E N E R A L C A R E • Donotimmersetheconsoleortweezersinwater. Treatment light on continuously. Contact is being maintained even when the tweezers are not in use. Clean tweezers with a damp cloth thoroughly, removing all traces of conductive gel. • Toenhancethelifetimeofyourtweezerskeepthem on the console unit and do not use them for any other purpose than intended. • Afteruse,wipethetweezerscleanwithaslightlydamp cloth, the console unit can also be wiped over. Rio, Dezac and Electrolysis Hair Remover™ are trademarks of The Dezac Group Ltd © The Dezac Group Ltd 2012 PO Box 17, Cheltenham Spa, England GL53 7ET www.riobeauty.com 1-IN-CNHR2-UK / 1.1 The destruction of the hair root cells continues for some time after the treatment has finished. It makes no difference whether you remove the hair immediately or not. If there is a particularly stubborn hair, an additional treatment or longer treatment time may be required. As with all hair removal treatments it is recommended that the area you have treated is washed with cool water and a mild antiseptic cream applied. warnings •Read all instructions thoroughly and retain for future reference. •This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. fitting the batter y STEP 5 5 Gel STEP 1 1 Only apply a gentle pressure on the tweezers, do NOT press the button fully (see step 7). You must use a bare finger on the tweezer button. Do not wear a glove. Release the clip to open the battery cover. B AT T E R Y 9 V P P 3 6 STEP 2 2 Take hold of the hair at the point where it meets the skin. STEP 6 © The Dezac Group •Do not treat the following areas: pimples, warts, hair on black spots or moles, dark freckles, skin disease, burns, eczema, or eyelashes. Connect a PP3 alkaline battery and replace battery cover ensuring it is shut firmly in place. B AT T E R Y 9 V P P 3 HA ir R E moval The amber treatment light will start flashing, indicating the treatment is in progress. If the amber light does not come on, check the tweezers are plugged in and that you are making a good contact with the hair at the point where it meets the skin. 7 When the treatment is complete you will hear a short bleep and the green ‘treatment complete indicator’ will illuminate. The hair can now be removed by increasing the pressure on the tweezer button to pluck the hair out of the hair follicle. (The unit will then automatically reset itself to start again). STEP 1 1 Wash area to be treated with warm water and mild soap. This will remove any excess oil from the skin. 2 STEP 2 Check the speed control is on minimum and turn the unit on with the On/Off button. STEP 7 © The Dezac Group The On/Off light will illuminate. CONDUCTIVE G EL •Not for use on or by children under 14 years old. Not for use on or by children between 14 and 17 years old without parental supervision. STEP 3 3 •Do not use after drinking alcohol or if you are feeling unwell or fatigued. professional range BODY CARE B AT T E R Y 9 V P P 3 Turn the Control dial to suit the type of hair being treated. The treatment time varies between five and thirty seconds depending on the setting (see hair treatment chart). H A I R TREATME N T C H ART •Please remove all jewellery in the vicinity of the treatment area before use. •There are no user serviceable parts inside the unit or wand. Do NOT dissemble or repair. If you have any problems using the product, contact our Customer Care Department. Hair Type Dial Setting Treatment Time Fine hair eg lip 2-5 5 - 15 seconds 8 STEP 8 If contact with the hair is broken during treatment the amber treatment light will go out and the unit will bleep three times. If the contact is not re-established within three seconds the treatment timer will assume you have moved onto a fresh hair and will restart the treatment programme. C ustomer C are If you have any questions, please call our Customer Careline on: +44 (0) 1242 702345 or email us at: [email protected] To register your two year guarantee www.riobeauty.co.uk/warranty.html online visit: © The Dezac Group 4 Medium hair eg eyebrow 6-9 15 - 25 seconds Thick hair eg bikini line 10 - 13 25 - 30 seconds STEP 4 Apply a small amount of conductive gel to the hairs which are to be treated OR put a blob of gel on the skin, into which you can dip the tweezers before taking hold of the individual hair. D isposal The Waste of Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC) has been put in place to recycle products using best available recovery and recycling techniques to minimise the impact on the environment, treat any hazardous substances and avoid the increasing landfill. The product is classed as Electrical or Electronic equipment so please ensure that at the end of the life of this product it is disposed of in the correct manner in accordance with local authority requirements. It must NOT be disposed of with household waste.