Your security is our challenge - RBtec Perimeter Security Systems

Transcription

Your security is our challenge
RBtec IRONCLAD sensor cable, Protection Concept
www.rbtec.com
Copyright © 2014 All rights reserved to RBtec Inc.
Alarm zone 1
2/13
www.rbtec.com
•
RBtec is recognized as a leading technology company specializing in the design, development, and
manufacturing of quality Outdoor Perimeter Detection technologies.
•
RBtec produces a wide variety of sensors for outdoor perimeter intrusion detection.
•
Many of RBtec products are self installed and user friendly designed.
•
RBtec provides an accurate, reliable, maintenance free, detection solutions.
3/13
www.rbtec.com
The IRONCLAD is an invisible, flexible rigid fence mounted sensor cable
The sensor cable can be installed on a fence of any kind, or similar tile roof, light walls, solar power panels.
The sensor can be connected to any standard alarm system panel, Scada or DVR.
Power Supply
12-24Vdc
The sensor cable protects the full
height of the fence up to 12ft.
4/13
www.rbtec.com
Potential Customers
•
•
•
•
•
•
•
Commercial and Industrial areas.
Car, RV, Boat or Equipment storage areas.
Solar & Wind farms.
Water, Electrical utility substations.
Courtyards of large houses.
Self Storage facilities.
Radio, Cellular, Communication antennas.
System advantage
•
•
•
•
The IRONCLAD system complements any alarm system, as well as integrates with CCTV camera system.
The IRONCLAD sensor is unique in its ability to protect the areas surrounding the site where there is high or thick
vegetation that does not allow installation of line of sight detector (Beams, PIR).
The sensor cable is armored and protected from small animals bite or tear due to continuous friction.
The IRONCLAD is installed outside connected to a local analyzer unit on the perimeter line.
Features
•
•
•
•
•
•
•
•
Ready for installation affordable kits.
3 Layers of False Alarm Filtration - Extreme low false alarm rate.
DIY - No special tool needed, comes with simple installation manual.
No calibration - The system self-calibrates
Maintenance free - 2 years warranty on the sensor cable.
11 Levels of sensitivity per zone
Dry contact relay outputs (NO or NC), can be connected to any alarm panel/DVR
Ideal for installation on chain link fences or concertina coils
5/13
www.rbtec.com
ATTENTION: The jumpers have to be
in the above position
Ironclad jumper
JP 5
CH 2
JP 6
CH 1
Zone 2
Zone 1
IMPORTANT: Install grounding
6/13
www.rbtec.com
Number of Zones
/ Zone Length
1 Zone
250ft
250ft
500ft
1000ft
2 Zone
250ft per Zone –
500ft System
500ft
500ft per Zone –
1000ft System
1000ft
1000ft per Zone –
2000ft System
7/13
www.rbtec.com
MCT- end of line
1
The sensor line attached along the internal side of the fence.
•First place the MCT end of line sensor in the end of the zone.
• Attach the cable to the fence with copper or plastic cable-ties.
•Connected the sensor cable to the analyzer.
•Connect to the analyzer to the alarm panel.
8/13
www.rbtec.com
Single/Dual Zone Microcontroller Module
(LPU-304).
Operating Power Requirements:
 12 – 24VDC 40mA @ 12VDC
Enclosure:
 NEMA 4x, IP-66
 9.5" x 7.5" x (24cm x 19.5cm x 7.0cm)
 Weight: (1Kg)
Lightening Protection:
 Gas Discharge Devices on all Inputs/Outputs &
Communication line.
Environment:
 Operating Temperature: - to ( to )
 Relative Humidity up to 98% non-condensing.
Alarm Outputs:
 Intrusion and Line monitoring output for each
zone.
 Dry contact relays with N.O. and N.C. contacts
rated 1A @ 12VDC.
Alarm transmission via RS-485 Protocol.
Sensor Cable & Accessories:
 Maximum length per zone: 1000ft (305m).
 Steel mash outer skin
 Diameter: (5mm).
 Color: Silver
Alarm Indicators:
 Power Status LED.
 Alarm Relay Status LED.
 Tamper Indication LED.
Connector:
F type Coax connection Sensor Cable Inputs for
each zone.
9/13
www.rbtec.com
 What does the kit include?
The Ironclad Kit includes at least a sensor cable in the length of choice, End line resistor pre-installed on the cable
and LPU303 (The analyzer) in a weather proof enclosure.
 How is the Ironclad system connect? And to where?
Each analyzer has 2 dry contacts relay outputs NO/NC, those outputs can be connected to ANY alarm system,
CCTV system or any other system that can accept dry contact input such as sirens, strobe lights and even fire alarms.
 How much fence can i cover with the Ironclad sensor?
The Ironclad sensor cable comes in spools of 250ft (75m), 500ft (150m) and 1000ft (300m).
Each Analyzer can control up to 2 zones which means the largest perimeter that can be covered with
1 kit is 2000ft (600m). In order to cover larger perimeter you can combine as many kits as you would
need to cover the whole fence line.
 Can the sensitivity of the sensor be adjusted?
Sure! The system has 11 levels of sensitivity that can be adjusted easily with dipswitches,
no need for software, laptop or any knowledge.
 Does the system needs any calibration before I can use it?
No, the Ironclad system is self-calibration, it is a plug and play system that requires power,
inputs and outputs to be connected and it’s working!
 Does wind or rain can cause false alarms?
The way the Ironclad system works: It detects only sharp frequency vibrations that are generated by cutting,
climbing or jumping the fence. Vibration cause by wind, rain and small animals are usually
long wave vibrations that would not be picked up by the system.
It's the difference between tapping/shaking the fence which will get detected to pushing on the fence like the wind that won' t.
On top of that we have an optional weather station that is able to feed the analyzer with
real time information about the weather around it and compensate on the wind and rain to give even
higher level of assurance of filtering out false alarms.
10/13
www.rbtec.com
 Does the weather station lower the sensitivity to avoid false alarms?
No, the weather station adds another variable into the algorithm of detection.
It does NOT just lower sensitivity to avoid false alarms.
 Can the cable be shortened?
Yes, the cable can be cut to size.
On one end of the cable the end of line resistor installed but on the other it's open and is cut to fit the fence length.
 Can the cable be installed on Sliding gate or Swing gate?
On swing gates the cable can't be installed as it might shorten the life span of the cable,
the cable would have to bypass the gate by a conduit under the gate.
On swing gates the cable can be installed but we would recommend installing it only on gates that are rarely used
so the cable won't break on the bending point of the gate from frequent opening and closing of the gate.
 Do we need to change to another cable to bypass a gate?
No, As long as the conduit is water proof the sensor cable can be put into the conduit directly
and by pass the gate and continue on the fence line on the other side.
 If the cable is cut can it repaired?
Yes! Repairing the cable is a 30 second process, RBtec offer a repair kit that uses as extension and junction box.
The box will be installed in the cut area, the sensor cable would go into the screw terminals on both sides of the repair box
and the system is back up and running.
11/13
www.rbtec.com
The meteorological unit screens extreme weather changes and minimizes false alarms
12/13
www.rbtec.com
Warranty :
• One year warranty for the electronics.
• Extended one year warranty for the IRONCLAD
• sensor cable (Two years)
This document has been written and produced by RBtec to provide the reader with as much technical and other information
as possible about RBtec its products and its services.
Copying any of its contents without prior permission from RBtec is strictly prohibited.
This information is provided for the purpose of initial evaluation of RBtec's products and services.
In keeping with RBtec's policy of continuous development, RBtec Ltd. reserves the right to alter these specifications without
notice.
Site: www.rbtec.com Email: [email protected]
13/13
www.rbtec.com

Your security is our challenge - RBtec Perimeter Security Systems

Transcription

Similar documents

rbtec.com [email protected]

- Included with Park Millennium Cable TV Package

your seventh sense - L

flyer! - Lm-therm Elektrotechnik AG

Two forces working with the weather…

MXCL-D0135-Maxcell Info Sheet.indd

CARDELL Quick Reference Guide

CableMaster Cable TesTer

GM MAF Instructions

LOROM High-Speed Products