finjet waterjet

Transcription

finjet waterjet
FINJET WATERJET
2 6.200 BAR HIGH PRESSURE CUTTING
HIGH SPEED AND ACCURATE CUTTING 5
12 WASTE REMOVAL SYSTEM
DRILLING UNIT 10
5 AXIS CUTTING 1
11 COLLISION SENSOR
4 WATERJET CONTROL
STACK CUTTING 7
3 TUBE CUTTING UNIT
HEIGHT CONTROL 9
8 WATERJET REMOTE CONTROL
MULTIPLE CUTTING HEADS 6
1
5 axis cutting: this technology enables complex
forms, dynamic cutting, bevel cutting, and 3D cutting. It
can also be used when cutting stacked materials.
5
High speed and accurate cutting: If time
is the most important aspect of your cutting work, we
have solutions that enable the fast movement (up to 40
meters /min) and very accurate results (0,1 mm).
2
6.200 bar high pressure cutting: when
cutting extremely strong and thick materials, high
pressure gets the job done precisely and effectively.
6
Multiple cutting heads: By adding cutting
nozzles, performance of the machine can be taken to new
level. With FinJet, you can freely add cutting heads and automatically control the distance and usage of each nozzle.
3
Tube cutting unit: Muototerä has developed a
special tube cutting unit to cut tubes and pipes into
any forms. This application can be featured in any Finjet
model.
7
Stack cutting: with Muototerä waterjets you can
cut multiple pieces with just one run. This saves time
and gives a better output for your production.
4
Waterjet control: Muototerä uses its own FinJet
machines in production every day. This enables us to
develop the usability of the machines continuously.
Muototerä control is fast to learn and easy to use.
8
Waterjet REMOTE control: FinJet waterjets can
be equipped with remote control (wireless or with cord),
mobile phone (SMS) control system, and web monitoring
systems.
9
10
11
12
Height control: With our height control system,
you can always get the best cutting results as the nozzle
is constantly monitoring the surface and adopting
automatically to optimal cutting height.
Drilling unit: For efficient cutting on composite
materials staring points can be automatically done by a
separate drilling unit.
Collision sensor: should a collision happen during
cutting, Muototerä collision sensor softens the impact
and stops the machine. After the obstacle has been
moved, waterjet cutting can be restarted immediately.
Waste removal systems: We can proudly say we
have the world’s best solution for waste management.
Sales
Vihiojantie 4
33800 Tampere, Finland
Mikko Jaakola
+358 45 112 3228
[email protected]
www.muototera.com
Tel: +358 (0) 3 225 4300
E-mail: [email protected]
Risto Kallio
+358 40 481 9388
[email protected]