KISS Alpha Centauri

,*44"MQIB$FOUBVSJ
6TFSHVJEF
Check online for the newest version of this guide.
Version 1.0
,*44"MQIB$FOUBVSJ
*ODMVEFE*O,JU
• 1 x Kiss Alpha Centauri
• 1 x Globe Glass Attachment
• 1 x Single Ti Gr 1 Coil
• 1 x Dual Ti Gr2 Coil
• 1 x 1701 Ceramic Coil
• 1 x 510 or 601 Skirt
• 1 x O-­Ring Kit &YQBOEFE7JFX
Mouthpiece
Glass Globe
Heat Shield
Globe Base
O-­Rings
WARNING !! Requires Persei or 8 Vaporizer for optimum use. Will work with Ophos, Minicron light series, and Omicron, but performance will be limited.
Stainless Shield
Globe Base
Coil
Bottom Assembly
WARNING !! Cartridges are HOT during and after
use. Do NOT touch the cartridge until after it has cooled off.
Bottom Assembly
O-­Ring
Air Control Shield
Bottom Base Plate
510/601
Skirt
Screws
Center Pin
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 1
,*44"MQIB$FOUBVSJ
$0.1-&5&6/*54
A. Kiss Alpha Centauri.
©
Copyright Utopia Planitia Technologies 2015
B.
Distributed by
Kiss Alpha Centauri Globe.
www.w9tech.com
Page 2
,*44"MQIB$FOUBVSJ
1SPQFS(SJQQJOH-PDBUJPOT
C.
When detaching Top Assembly from Bottom Assembly or detaching Globe Glass
Assembly from Bottom Assembly: hold the unit only at the locations specified
by the arrows below.
Top
Assembly
Globe Glass
Assembly
Bottom
Assembly
Bottom
Assembly
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 3
,*44"MQIB$FOUBVSJ
-PBEJOH$PJMT
1a. Unscrew Top Assembly from
Bottom Assembly.
1b. Unscrew Globe Glass Assembly from Bottom Assembly.
Top
Assembly
Globe Glass
Assembly
Bottom
Assembly
Bottom
Assembly
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 4
,*44"MQIB$FOUBVSJ
-PBEJOH$PJMT
Top Down View
Apply Concentrate
to shaded area.
• DON'T: Touch the heating coils.
• DON'T: Rub oil on the heating coils.
• DON'T: Touch the heating coils with a metallic applicator or damage may result.
• DON'T: Make direct contact with the heating coils.
• DO: Drip oil over the heating coils.
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 5
,*44"MQIB$FOUBVSJ
-PBEJOH$PJMT
3a. Screw Top Assembly on to
Bottom Assembly.
3b. Screw Globe Glass Assembly on to Bottom Assembly.
Top
Assembly
Globe Glass
Assembly
Bottom
Assembly
Bottom
Assembly
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 6
,*44"MQIB$FOUBVSJ
$IBOHJOH$PJMT
4a. Unscrew Top Assembly from
Bottom Assembly.
4b. Unscrew Globe Glass Assembly from Bottom Assembly.
Top
Assembly
Globe Glass
Assembly
Bottom
Assembly
Bottom
Assembly
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 7
,*44"MQIB$FOUBVSJ
$IBOHJOH$PJMT
5a. Unscrew Single Coil from
Bottom Assembly.
5b. Screw Dual Coil on to
Bottom Assembly.
©
Copyright Utopia Planitia Technologies 2015
-­OR-­ 5c.
Distributed by
Screw 1701 Coil on to Bottom Assembly.
www.w9tech.com
Page 8
,*44"MQIB$FOUBVSJ
$IBOHJOH$PJMT
6a. Screw Top Assembly on to
Bottom Assembly.
6b. Screw Globe Glass Assembly on to Bottom Assembly.
Top
Assembly
Globe Glass
Assembly
Bottom
Assembly
Bottom
Assembly
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 9
,*44"MQIB$FOUBVSJ
BUUBDIJOH(MBTTHMPCF
7a. Unscrew Top Assembly from
Bottom Assembly.
7b. Screw Globe Glass Assembly on to Bottom Assembly.
Top
Assembly
Globe Glass
Assembly
Bottom
Assembly
Bottom
Assembly
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 10
,*44"MQIB$FOUBVSJ
"UUBDIJOH4LJSU
8.
Remove both screws, and slide
off Bottom Base Plate.
9.
Align holes of 510/601 Skirt,
and screw to Bottom Assembly. Screws
Screws
Bottom
Base Plate
Bottom
Assembly
510/601
Skirt
Bottom
Assembly
WARNING !! Holes must be aligned when attaching either the Bottom Base Plate or the 510/601 Skirt, prior to inserting and screwing
in screws. WARNING !! Screws must be centered. If screws are not completely
vertical, or are at an angle, or do not screw in easily: stop immediately
and realign screws before continuing. Once screws realigned, try again. ©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 11
,*44"MQIB$FOUBVSJ
"EKVTUJOH"JS'MPX
10. Twist Air Control Shield to
Adjust Air Flow.
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 12
,*44"MQIB$FOUBVSJ
3FNPWJOH(MPCF(MBTT
11. Screw Globe Glass Assembly
to Bottom Assembly.
12.Remove Globe Glass by twisting clockwise and gently pulling off.
Globe Glass
Globe Glass
Assembly
Bottom
Assembly
©
Copyright Utopia Planitia Technologies 2015
Bottom
Assembly
+
Globe Base
Distributed by
www.w9tech.com
Page 13
,*44"MQIB$FOUBVSJ
$MFBOJOHBOE.BJOUFOBODF
13. Screw Mouthpiece counter
clockwise to remove.
14. Slide Heat Shield off Stainless
Shield to remove.
Heat Shield
Mouthpiece
Heat Shield
+
Stainless Shield
+
Bottom Assembly
©
Copyright Utopia Planitia Technologies 2015
Stainless Shield
+
Bottom Assembly
Distributed by
www.w9tech.com
Page 14
,*44"MQIB$FOUBVSJ
'"2T
Your Kiss Alpha Centauri has been designed to be easy to care for and maintain.
By following these simple maintenance steps, you will keep your Kiss Alpha Centauri performing at peak performance.
Depending on your frequency of usage, the electrical contact points should be cleaned at least once a week. The Kiss Alpha Centauri uses relatively low voltage to operate and even a small amount of residue on the contact points and/or threads can reduce the voltage flow, impeding the performance of your Kiss Alpha Centauri. Any residue bridging the gap between the threads and center post on your Kiss Alpha Centauri, could cause a very dangerous electrical short resulting in physical injury to yourself and damage to the battery and/or your Kiss Alpha Centauri. KEEP IT CLEAN !! A. To clean the electrical contact points and threads, take a cotton swab (”Q-­Tip”) and dip one end into A. some Isopropyl Alchol (”ISO”). The higher percentage of purity, the better, try to use as close to 99% A. ISO as you can.
B. Using the ISO dampened end of the cotton swab, gently scrub and clean any residue from all the
B. contact surfaces and threads on your Kiss Alpha Centauri and Vaporizer. The contact surfaces are all B. the areas that make contact with each other when the Kiss Alpha Centauri is screwed into the B. Vaporizer.
C. Once cleaned, use the dry end of the cotton swab to help the drying process by gently running it over C. the areas just cleaned. Be careful that no cotton gets left behind on any surfaces or threads.
C. After every thing is completely dry, lightly touch the contact areas and threads with your fingers. If C. you feel any tacky areas, please repeat the cleaning procedure steps A -­ C again until all the contact C. areas and threads are tack free.
• DO: Use ISO to clean the contact areas and threads on all your cartridges. • DO: Use ISO to clean the contact areas and threads on your Vaporizer.
• DO: Keep your Lithium Ion batteries charged and in good physical condition.
• DO: Submerse your cartridge in 99% ISO to clean (Do NOT submerge plastic mouthpiece).
• DON’T: Try to use a cartridge still damp with ISO.
• DON’T: Leave behind any lint or cotton on the cleaned surfaces or threads.
• DON’T: Screw a cartridge on to the Vaporizer with out cleaning both first.
• DON’T: Allow a fully charged battery to sit in the charger for extended periods of time.
• AVOID: Using metallic applicators on the KISS cartridges, you will damage the heating coil.
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 15
,*44"MQIB$FOUBVSJ
'"2T
What are the DO’s and DON’Ts?
• DO: Check your Kiss Alpha Centauri for damage such as a cracked ceramic wick, or dislodged wires.
• DO: Pull air through the cartridge VERY SLOWLY.
• DON’T: Blow air into the cartridge.
• DON’T: Get any oils, waxes etc. into the threads during filling.
• DON’T: Excessively tighten the KISS cartridge on to the Vaporizer.
• DON’T: Inhale hard, you will suck extract into the mouthpiece.
• AVOID: Extract oils that are too thin or runny at room temperature, or poorly processed / purged.
Will the Kiss Alpha Centauri fit other vaporizer batteries?
The Kiss Alpha Centauri is made to specifically for the Persei and 8 vaporizer, but understanding that many of our clients would like to use their own batteries we have manufactured a 510 version as well. It will not fit visually on all batteries but it will fit them all. the Coils might not work with all batteries because the demand in power for the dual coil and 1701.
What types of essential oils can I use?
Any essential oil that will liquefy with heat and thicken at room temperature that preferrably was not
produced using water or ice extraction. There should be no plant material left in the extract.
My cartridge is leaking, what can I do?
The most common reasons for leaking cartridges are:
• Overheating the cartridge during use or storage in a hot area.
• Blowing air into the cartridge.
• Inhaling too hard, try sucking very slowly and lightly.
• Inhaling too soft, try sucking a little harder, but not too hard.
• Over filling the cartridge, 0.3 gram is the maximum capacity.
• Using oil that is too thin or low quality / poorly processed / purged will leak.
I hear bubbling sounds when I inhale, is this normal?
No, bubbling is caused by extract that is too thin at room temperature and/or has impurities in it
from not being processed / purged correctly. These extracts are not recommended and will cause
your cartridge to leak and generally under perform.
My cartridge is defective, what can I do?
Cartridges are not warrantied after the first 24 hours of receipt and must not be used to have a replacement sent out to you. In order to check your cartridge: screw it on the Vaporizer and press the power button for no longer then 1 second. If you see a faint glow it is working.
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 16
,*44"MQIB$FOUBVSJ
8BSOJOHT
WARNING !! If unit gets warm: shut it down and quickly remove the batteries and contact Up Tech.
WARNING !! If smoke is produced from the unit or if the unit catches fire: quickly disconnect the cartridge, place it in water, and contact Up Tech.
WARNING !! UP TECH is not responsible for: 1) Any damage to personal property or 2) Any bodily harm, the Vaporizer may cause.
WARNING !! Using a variable voltage vaporizer might damage the Kiss Alpha Centauri.
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 17
,*44"MQIB$FOUBVSJ
For more help please submit a ticket on: www.w9tech.com.
For wholesale inqueries please contact: [email protected].
Sincerely,
Gary Bay
UP TECH
©
Copyright Utopia Planitia Technologies 2015
Distributed by
www.w9tech.com
Page 18