Vector Media

Vector Media™ is available with either cherry or black doors and can
be free standing or wall mounted. The doors can be closed, completely
concealing your CD’s, DVD’s, or VHS tapes, or can be swung wide
open for easy access.
To learn more about BDI’s complete line of home theater furniture, visit us
on the web at www.bdiusa.com.
Placement and Maintenance
Vector Media™ Home Theater Furniture is designed for indoor use on
level floors (not recommended on deep pile carpet, as stability
may be compromised). Clean glass with glass cleaner, and wood and
metal parts with a moist cloth.
HIGH PERFORMANCE
FURNITURE FOR YOUR
HOME THEATER
Product Specifications
Overall Dimensions:
56.125”H x 14.25”W x 10.25”D
Storage Capacity:
190 CD’s, 85 DVD’s, 40 VHS tapes,
or any combination.
Designed by Carlo Patti
‘Vector Media’ is a trademark of Becker Designed, Inc.
All rights reserved.
©2002 Becker Designed, Inc.
Vector Media™
Becker Designed, Inc.
Assembly Instructions
Components
A
B
20mm Flat head
Screw 3x
Stem 1x
H
B
12mm Pan head
Screw 14x
A
C
Base 1x
25mm Pan head
Screw 2x
Shelf Support Rods 12x
Hex Wrench 1x
Figure 5
D
Cabinet 1x
Glass Shelves 6x
Figure 4
Doors 2x
Clear Plastic
Sleeve 26x
G
H
Screw 4x
E
F
Adhesive Glide 4x
Wall Anchor 4x
Door Bumper 2x
Key Hole
G
Door Stop
F
3. Free standing. To install optional base, start with Fig. 1 & 2 (skip Fig. 3). Lay
cabinet face down on floor. Slide the top of the stem between the cabinet and
the rotating door brackets (Fig. 1). Fasten stem in place with (6) 12mm pan head
screws using hex wrench. Attach doors stops using 2 -25mm pan head screws (C)
and 2 plastic sleeves (D) as shown (Fig. 2). Next, attach base to stem with 3- flat
head screws (A) using hex wrench (Fig. 4). For wood, tile or slate floors, install
adhesive glides(H) in corners of base as shown (not needed on carpeted surfaces).
4. Attach doors & door bumpers. Push 2 door bumpers (E) into holes on top
and bottom face of cabinet (Fig. 6). Using (8) 12mm pan head screws (B) and hex
wrench, attach doors as shown (fig. 5 ). Easiest installation is with unit face down
on non-marring floor. Doors may be attached in an upright position as well.
D
E
B 6x
C
D
1
C
D
C
Figure 1
Start Here
D
2
Figure 2
G
3
G
Figure 3 (Optional)
1. Unpack and identify the parts listed above. The assembly area surface
should be non-marring such as carpet. If any parts are missing or damaged contact BDI Customer Service at: [email protected]
2. Wall mounting (optional). To hang your Vector Media on a wall, start with
Fig. 2 & 3 installing door stops and inserting wall anchors using key holes as a
guide. Recommended distance off the floor is 10-16”. Next, proceed to Step 4.
Figure 6
Figure 7
Figure 8
5. Assemble shelf support rods. Slip (2) plastic sleeves (D) onto each shelf support rod as shown in Fig. 6. Insert shelf support rods at desired positions into the
holes inside cabinet walls as shown in Fig. 7.
6. Insert glass shelves as shown in figure 8. Adjust shelve spacing to best accommodate your media.
Enjoy!