Installation Instructions for Soft-Close Base Filler - Rev-A

Transcription

Installation Instructions for Soft-Close Base Filler - Rev-A
Installation Instructions for Soft-Close Base Filler with
Slides
Note: Do not remove front shipping strap prior to installation!
TOOLS REQUIRED:
3/16”
ESTIMATED ASSEMBLY
TIME:
CARE AND MAINTENANCE:
20 MIN
CLEAN WITH A DAMP CLOTH
AND WIPE PARTS DRY
Cabinet Wall
Step 1. Measure scribe rail thickness and length per your
specific cabinetry. (See Fig 1a and 1b)
Scribe Rail
Length
Scribe rail measurements
Scribe Rail
Front of Cabinet
width dimension
Front of Cabinet
Fig 1b
From
Fig
1a inside the adjacent
cabinet screw the 432 to
cabinet top.
Fig 2
Step 2. Install upper and lower scribe rails to filler pullouts being careful not to split the
Fig 4c Wall Cabinet
wood. If using screws to attach, be sure to pre-drill first. Align scribe rails with front edge of
filler
h holes
3/8pullouts. Align scribe rail to upper section of base cabinet lower mounting. (See Fig 2)
7-3/4”Note:
down If installing pullout in a frameless application, it is recommended to that a 1/16” thick
with other
scribe rail be used to space the filler unit properly.
Screw 432 to cabinet bottom
Top Scribe Rail is nailed
to edge of top section
from below adjacent cabinet.
ts Face Frame
Shipping Strap
Screw 432 to cabinet top
from above adjacent
cabinet.
Bottom scribe rail is nailed
to edge of bottom section
Step 3. Pre-drill 3/16” holes 3/8” down from top of cabinet and also
27-3/4” down from top of cabinet. (See Fig 3) Repeat with adjacent cabinet.
Fig 4d Base Cabinet
From inside and
above the adjacent
ce Frame
Fig 3
the 432 to cabinet
bottom.
Step 4. Mount filler cabinet pullout to adjacent cabinet. Make sure filler is flush
with the top of the cabinet wall and behind the face-frame if applicable.
Step 5. Mount filler cabinet pullout to remaining adjacent cabinet.
See Fig. 6
12400 Earl Jones Way • Louisville, KY 40299
800.626.1126 • FAX: 502.491.2215
www.rev-a-shelf.com
I-432SC-1112
Install onlay using slots
for side to side adjustment
Fig 4
Shipping Strap
Use micro adjustment screw
for door tilt adjustment
Fig 5
Step 6. Remove front shipping strap. (See Fig 4)
Step 7. Attach onlays or door panels. (not provided). (See Fig 5)
Disassembling the pullout from the chassis
Note: Your pullout unit does not need to be removed for installation. If you encounter an issue that requires the unit to be removed, the release levers
for the Blum Tandem slides are located as shown. (See Fig 6a-b).
Fig 6b
Back of pullout
Fig 6a
Top slide
release lever
Bottom slide
release lever
2
Front slide height adjustment
2
1
Adjustable Tab
1
Fig 7b
2
Step 1. Press up on adjustment tab.
Step 2. Push toward back of unit. Maximum 1/8” rise of filler.
(See Fig 7a-c)
Adjustable Tab
Fig 7c
1
Fig 7a