2012 Motivational Tubing Jr Comp/Mini Dragster (Suzuki Hayabusa

10/08/2012
2012 Motivational Tubing
Jr Comp/Mini Dragster (Suzuki Hayabusa powered)
We have for sale a 2012 MT Jr Comp/Mini Dragster that was ordered, built and
paid for but never left the shop due to a change in plans by the customer. This is
a new turney “07” Suzuki Hayabusa powered car built with all of the ‘good stuff.’
To be sold at a discount! The original invoice was for
$29,953.32 but the customer will take $25,950.00. See
details & pictures below. Call Arlen at 316-283-7301 or
send an email to [email protected].
Motivational Tubing’s entry into the Jr Comp/Mini Dragster ranks was designed from the ground up to be a
car capable of the 1/4 mile as well as the 1/8th mile. It features quality components - from the Anglia style
spindles and full size front tires/wheels to a 22” wide SFI 2.7C certifiable cage and a purpose-built 2” splined
rear end assembly - that are all designed to handle the horsepower and speed possible with one of these cars.
body
Body group (see picture above)
• Aluminum body asm
• Fiberglass nose
• Tinted Lexan windshield
• Pivoting body mtg arms to allow chassis to flex without putting the body in a bind
chassis (Black powdercoat)
The chassis is a 188” wheel base, modular 3 piece
design.
The pre-loaded slip joint front clip gives the car more
front clip flex to aid in the smooth and consistent
transfer of weight to the rear tires while some
additional bracing preserves torsional stiffness to
minimize chassis roll. A safety stop is also build in to
prevent over travel.
The 22” wide rear engine dragster roll cage has been
certified to SFI specification 2.7C. This spec defines tube
sizes and configuration for cars running 7.50 seconds and
slower in the 1/4 mile. It has been designed with taller cage
sides and 14” roll bar height for driver comfort. It comes
with a 1/8” aluminum deflector panel.
The rear clip has been engineered to fit most motorcycle
and snowmobile engines simply by bolting on the
appropriate mounting plates and brackets.
The structure of the rear clip is designed to handle the
higher horsepower turbocharged engines as well.
interior
Interior features
• Aluminum floor, under seat & bulkhead panels
• 22” wide laydown (semi laydown interchangeable)
• SFI roll bar padding
• 5 point harness
• Black pebble finish floor covering
steering
The steering components are specified to accepted
1/4 mile dragster standards
• Anglia style aluminum spindles
• Stiletto rack & pinion
• SFI certified quick release
• Full size steering wheel w/grips
pedals
Standard Pedals group includes
• Adjustable pedal mtg plate asm
• Brake pedal
• Throttle pedal w/pullback
• Dual throttle cables w/adjustable bellcrank asm
• Pressure switch for 2 step
axle/brake
Rear Axle group
• 2” OD 31 tooth splined aluminum tube axle
• Axle mtg plates for 26”/28” OD tires
• Bearings, cassettes and sleeves
• Heavy duty sprocket hub
• Axle spacer set for center pull or side pull assembly
• 15 bolt splined rear wheel hubs
Brake group
• Dual Wilwood Dynapro calipers
• Wilwood master cylinder
• Dual 10” rotors and hubs
• Stainless braided brake line
tires/wheels/hubs
Rear wheels/tires
• 15”x10” 15 bolt wheels
• M/T 28.0/10.5-15 rear tires
Front wheels/tires
• Weld 17”x2.25” Black V-Series Wheels
• M/T 22.0/2.5-17 ET Front Tires
engine/mtg/chain
This car includes
• 2007 Suzuki Hayabusa (7,976 miles)
• 530 Regina Drag Chain
• Positive Adjust Idler Sprocket
clutch/shifter
• MTC Slider Clutch
• MPS Air Shifter
• Air Compressor (automatic)
• Manual Shift Lever
header shield
coolant system
Saldana Dual Pass Radiator w/fan
Custom aluminum coolant lines
with radiator fill cap
Coolant Recovery Tank
fuel system
• 1 Gallon fuel tank
• MSD fuel pump
• 35 Micron fuel filter
• Fuel pressure regulator
dash/controls
Gear position indicator w/TRE
Manual airshift control button
on steering wheel
• Koso Gauge Cluster (tach, temp, shift light)
• Autometer Oil Pressure Gauge
• Autometer Voltmeter Gauge
• Autometer Shift Air Pressure Gauge
electrical, rear
• Modified motorcycle wire harness
• MPS Air Shift (auto or manual button)
• MSD Launch Master
• Electrical component storage box
• Battery box w/ shutoff switch
• Odyssey deep cycle dry battery