Fender PD250 Speaker System Set-Instructions

Transcription

Fender PD250 Speaker System Set-Instructions
Fender PD250 Speaker System Set-Instructions
Unclip speakers from
amplifier and find (1) power
cord and (2) 25’ speaker
cords in compartment.
With unit turned off plug
power cord into surge
protector and into the back
of amplifier.
Plug speaker wires into
“speaker out” on amplifier
and into speakers.
Turn unit on and adjust
master volume to “5”
Microphone located in
amplifier compartment.
Plug into amplifier, turn
“on” and adjust volume as
needed.
Plug in external device such
as CD player into “Stereo 1”
RCA jacks and adjust volume
at “Stereo 1” control knob.
Adjust EQ high and low as
desired. Do same to REV
(reverb) and BAL (balance).
Normal settings are shown.