owner`s manual utg recon 360

Transcription

owner`s manual utg recon 360
SWIVEL STUD MOUNT INSTALLATION
UTG RECON 360
1
BIPOD
PICATINNY & SWIVEL STUD MOUNT
Locking
Pin
4
2
3
6
7
Swivel Stud
Adaptor
Swivel Stud Mount
OWNER’S MANUAL
For Model: TL-BP01
Locking
Nut
5
U.S. PATENT PENDING
MUB018011504
FEATURE ILLUSTRATION
Assembly Complete
Refer to the PICATINNY MOUNT
INSTALLATION to install the
bipod on the rail provided on the
Swivel Stud Mount.
Note: Do not completely remove the tension adjustment screw, this may cause damage
to the bipod and void warranty coverage.
3
Flat Head
Screwdriver
Bipod Attachment
Offset Picatinny
Mounting Deck with
Square Steel
Cross Bolt
Two Tension Adjustment
Screws on Two Sides of
the Main Base
O
pe
nA
PANNING AND TILTING
1
2
360-degree Panning
and Multi-axial Tilting
ngle 50°
Lockable Thumb
Wheel to Securely
Lock Extended Leg at
Desired Length
360 °Panning
The inner smart spherical
structure of the bipod base
allows full 360 degree
rotation of the firearm.
Front/Rear Tilting
Side Tilting
Multi-axial tilting allows total flexibility in
front-back, sideways or any other directional
movement of the firearm.
BI-DIRECTIONAL FOLDING OPERATING INSTRUCTION
Center Height
Bipod Legs with 5 Notches
(0.68” Apart) for Most Positive
Extension
Heavy Duty Non-slip
Rubberized Foot Pads
Model
Stand Type
Center Height
(Min - Max)
Leg Length
(Min - Max)
Extendable
Leg
Open
Angle
Picatinny
Mount
Swivel Stud
Mount
TL-BP01
Rubberized
6.7” - 9.1”
7.4” - 10.2”
Yes
50°
Yes
Yes
1
2
Coin
To increase or reduce the panning
and tilting tension, use a coin or a flat
head screwdriver to tighten(clockwise) or
loosen(counter clockwise) the two tension
adjustment screws evenly.
3
Press down and hold the Leg Folding Fold the bipod leg forward or backward to one of the 45° or 90° (Degree)
Clamp located at the top of each leg. positions. Release the Leg Folding Clamp when the leg is in desired position
for a solid lock.
LEG EXTENSION/RETRACTION INSTRUCTION
Swivel Stud Kit
(Also Sold Separately)
1
2
3
Make sure the Lockable Thumb
Wheel is fully released by turning it
counter-clockwise.
Extend the bipod leg by pulling it out
of the leg housing. Set it at any of the
pre-cut extension notches. Or, extend
to any location in between notches.
Tighten the Thumb Wheel by turning
it clockwise to lock the leg to position.
To retract the bipod leg, loosen the
Lockable Thumb Wheel first. Press down
the Leg Retraction Clamp before you
push the extended leg upward into the
housing.
TL-BPAD1
PICATINNY MOUNT
SWIVEL STUD MOUNT
PICATINNY MOUNT INSTALLATION
1
Thumb Nut
2
3
Loosen the Thumb Nut
and fit the cross bar in
the mounting base into
a Picatinny rail slot.
Tighten the Thumb Nut
securely.