ZL1 Camaro Dual Mode NPP Exhaust wireless controller

ZL1 Camaro Dual Mode NPP Exhaust
wireless controller
Please read all instructions before install.
Installation is done at the owners or installers risk. Seller is not responsible
for any damages or injury caused from installing or using this product. No
refunds or returns on this product. If defective it will be replaced only. This
product carries a Lifetime Replacement warranty.
The Exhaust Commander allows you to take Full Command of your ZL1 Camaro Dual
Mode Exhaust.
Exhaust Commander gives you the ability to open and close the butterfly valves in the
exhaust on demand.
When the butterfly valves are closed the car will operate just like a stock car would. You
can choose to open and close the butterflies with the supplied wireless remotes whenever
you want. When the butterflies are your ZL1 will have the true muscle car sound!
This kit will allow the Stock ZL1 Camaro mufflers to be controlled via the supplied keyfob
remote or the Homelink universal visor remote.
Tools Needed:
10mm Socket ( for ground ring ).
Step 1:
Open the trunk of your car. You will need to access the fuse block in the rear
passenger side.
Step 2:
Locate and remove the Exh Flap fuse at location F8. Also, loosen the 10mm
bolt holding the ground ring using a 10mm socket.
Step 3:
Plug the Exhaust Commander fuse adapter into the Exh Flap fuse slot F8 with
the wires routed towards the top as shown.
Step 4:
Place the Exhaust Commander ground ring under the chassis ground ring and
tighten the 10mm bolt back down. Affix the Exhaust Commander unit to the
body using the supplied Velcro. You can now replace the fuse block cover.
Step 5:
Start the Car and raise the engine RPM high enough to close the butterflies. Use
the unit’s remote to verify open and closing of the Muffler Butterfly Valves.
Step 6:
Go out and make some noise! Enjoy your Exhaust
Commander wireless exhaust controller.
Programming Remote to Homelink universal remote
Your vehicle’s engine should be turned off while programming the transmitter .Follow
these steps to program up to 3 channels.
#1) Press and hold down the two outside buttons, releasing only when the indicator light
begins to flash, after 20 seconds. Do Not hold down the buttons for longer than 30
seconds and DO NOT repeat this step to program the second and third buttons.
#2) Position the end of your hand held transmitter about 1-3 inches away from the
homelink® buttons while keeping the indicator light in view.
#3) Simultaneously press and hold both the desired button on homelink® and the hand
held transmitter button. Do Not Release buttons until step 4 has been completed!
#4) The indicator light on homelink® will flash slowly at first and then rapidly after
homelink successfully receives the frequency signal from the hand held transmitter. Do
not release the buttons until the red light stops flashing.
#5) Press and hold the newly trained homelink® button and observe the indicator light.
If the indicator light stays on constantly, programming is complete for that button and
should activate the device when the button is pressed and released.
To program the remaining button begin with step 2.
Do Not repeat step 1 as this will
erase all of the programmed buttons.
This product has a Lifetime Replacement Warranty.
For warranty claims use the contact form at www.sunsetorangecreations.com
Copyright - Sunset Orange Creations 2012 Ver 1.1 – 1/1/2012