9069149 Jamb Liner Pocket Cover Replacement for

Jamb Liner Pocket Cover Replacement
for E-Series Double-Hung and Single-Hung Windows
Thank you for choosing Andersen.
For questions call 1-888-888-7020. For more information and/or guides visit www.eaglewindow.com
Please leave this guide with building owner.
▶▶ Read guide from beginning to end before starting maintenance procedure. Read all warnings and cautions during unit maintenance.
▶▶ For information, calculating, and design pressure ratings for E-Series windows and doors go to
www.eaglewindow.com/Wintelligence/Design-Pressure-Estimator.aspx
▶▶ Check with your local building code official to identify and confirm compliance with local building code requirements.
Parts Included
(1) Jamb Liner Pocket Cover
Tools Needed
∙∙ Safety Glasses
Jamb Liner Pocket Cover
Windows and doors can be heavy. Use safe
lifting techniques and a reasonable number of
people with enough strength to lift, carry and
install window and door products to avoid injury
and/or product damage.
Use caution when working at elevated
heights and around unit openings. Follow
manufacturers’ instructions for ladders and/
or scaffolding. Failure to do so may result in
injury or death.
“Andersen” and all other marks where denoted are trademarks of Andersen Corporation and its subsidiary. ©2013 Andersen Corporation. All rights reserved.
Follow manufacturers’ instructions for hand
or power tools. Always wear safety glasses.
Failure to do so may result in injury and/or
product damage.
9 0 6 9 1 4 9 BA
Revised 06/03/13
1
2
Interior
Interior
Lock Handles
Lock Handles
4 Inches
Unlock window and raise bottom sash 4 inches.
Rotate and hold lock handles toward center while tilting sash in
90 degrees.
3
4
Interior
Interior
Bottom Sash
Pocket Cover
Pivot bottom sash to remove from window frame as shown.
Place sash on clean flat work surface, exterior side up.
5
Grasp jamb liner pocket cover at bottom and pull outward and
down from behind head stop to remove and dispose of properly.
6
Beveled Side
Interior
Interior
Head Stop
Jamb Liner
Pocket Cover
Jamb Liner
Pocket Cover
Interior
Channel
Press jamb liner pocket cover firmly into place, starting at top,
zippering down full length.
Insert top of new jamb liner pocket cover, beveled side toward exterior,
into interior channel, sliding it up behind head stop.
9 0 69149
2
7
Interior
8
Balance
Shoe
Interior
Interior
Channel
Lock Handles
Pivot Pin
Rotate bottom sash to engage pivot pins into balance shoes of interior
channel. Push down until both pivot pins are fully engaged.
Tilt sash up, retracting tilt latches by rotating lock handles toward
center, then release lock handles to re-engage sash.
9
10
Interior
Interior
Lock Handles
Lock Handles
Verify sash operation. Repeat steps 7-8 if sash does not
operate correctly.
Close and lock window.
▶▶ Jamb Liner Pocket Cover Replacement procedure is complete.
9 0 69149
3