battle belt - Tactical Tailor

BATTLE BELT
INCLUDES:
1x Left Side
1x Right Right
1x Center Lumbar
Instructions:
Step 1.
• Determine your desired length of the Battle Belt end to end. Do this by measuring your waist and decide how
far you want the ends of the Battle Belt to wrap around your body.
• Lay the belt out flat and determine which of the three adjustment loops you need to weave the belt through in
order to meet that desired length.
Step 2.
• Starting at one
end, thread the belt
through the end
Cordura ® retainer.
*Note*The Elastic
Belt loop is to
secure the belt end.
Step 3.
• Thread through
the second
retainer, this is
the webbing with
the Harness
D-Ring.
• Now is the time to
weave any holsters
or drop-leg systems onto your belt
before moving onto
the next step.
Step 4.
• Align the
lumbar end
retainer and
the adjustment
loops.
2916 107th St So.
Lakewood WA, 98499
www.tacticaltailor.com
Step 5.
• Pull the adjustment loop up through the lumbar end
retainer and thread the belt through the adjustment loop.
*Note* this is the key to whole system and if not
properly woven together the system will not function
properly. Be sure to thread the belt through the Webbing
retainer located behind the MOLLE Panel of the lumbar
component.
Step 6.
• Once through the
other side of the
Lumbar Component,
repeat steps 1-5 in
reverse order.
Step 7.
• Be sure to weave on any holsters or drop-leg systems through the
provided access slots.
• After everything is in place and sides are closed weave on
whatever pouches you desire. This will also prevent the sides from
opening on their own.
2916 107th St So.
Lakewood WA, 98499
www.tacticaltailor.com