Compensator Eliminator #4513

603-668-6315
WWW.VULCANWORKS.NET
Compensator Eliminator #4513
Instructions for most 2006-10 Bikes with stock
style compensator shown to the right.
*Remove Primary Cover
*Remove Compensator Bolt
*Remove Clutch Hub, Chain and Compensator
together.
This step is optional, but leaving the spring
pack in may cause noise and/or an imbalance.
*Slide Alternator Rotor off shaft
Bend one of the tabs back and slide out
all of the belleville springs
Manufactured by
Motorway Engineering
85 Hancock St. Manchester, NH, 03101
USA
603-668-6315
WWW.VULCANWORKS.NET
Springs Removed
• Mount Alternator Rotor back on shaft
• Important: Refer to the Service Manual for your bike for
a complete installation procedure.
• The Motor sprocket, Chain and
Clutch hub must be installed at
the same time.
• Install Bolt with red Loctite and
included washer(Recessed
Side toward Motor).
• Torque To 140-165 FT-Lbs
603-668-6315
WWW.VULCANWORKS.NET
Instructions for most 2010-up Bikes with
Screaming Eagle style compensator shown
to the right.
*Remove Primary Cover
*Remove Compensator Bolt
*Remove Clutch Hub, Chain and Compensator
together.
• Important: Refer to the Service
Manual for your bike for a
complete installation procedure.
• Install included Large Washer
onto motor sprocket shaft.
•
• The Motor sprocket, Chain and
Clutch hub must be installed at
the same time.
• Install Bolt with red Loctite and
included washer(Recessed Side
toward Motor).
• Torque To 145-165 FT-Lbs