Installation Manual for Lowering Module Bentley Continental GT

Installation Manual for
Lowering Module
Bentley Continental GT
Coupe/Speed
• Unclip and remove the driver-side rear seat’s lower seat
cushion
• Unclip and remove the arm rest and disconnect the
window switch
• Unclip and remove seat-back side trim to expose seatback bolts
• Remove T30 Torx and 10mm Nut
• Remove rear seat back
• Remove side wood trim panel (4 x T25 Torx)
• Remove rear seat belt bracket (2 x T25 Torx)
• Remove driver’s seat belt retraction device by gently
pulling straight out until track disengages from
sprocket
• Remove two 10mm nuts on the bottom of window
panel
• Remove T25 Torx on silver driver’s seat belt trim
• Remove T20 Torx on lower trim
• Remove 10mm and 8mm bolts behind wood trim
• Unclip panel by prying out and up to unclip from
retention clips
• Disconnect speaker connectors and remove panel
• Locate and disconnect factory Suspension Module
harness connectors and follow RENNtech DLM
Installation Instructions associated with vehicle model