THE EYECON LED
Transcription
THE EYECON LED
THE EMERGENCY LIGHTING SPECIALISTS THE EYECON LED AESTHETICALLY PLEASING SUSTAINABLE EFFICIENT DISCREET AESTHETICALLY PLEASING SUSTAINABLE EFFICIENT A VISUALLY INNOVATIVE APPROACH TO DISCREET AAVISUALLY VISUALLYINNOVATIVE INNOVATIVEAPPROACH APPROACHTO TO LED LEDEMERGENCY EMERGENCYLIGHTING LIGHTING The development of the EYECON LED range marks yet another unique progression in LED emergency lighting. Another key strength of the EYECON LED is the reduced power consumption of the LED emergency module. The EYECON LED is specifically designed to offer a cohesive surface mounted escape route and open plan emergency lighting solution within a specific project, maximising emergency light distribution and offering long term cost savings to The EYECON LED module charges the Ni-Mh battery at 40% power the client. consumption compared to a conventional Ni-Cd charger. These low parasitic power consumptions offer the client considerable long Designed to seamlessly integrate into the interior aesthetic of prestigious modern developments and produced from the term cost savings. highest quality materials, the EYECON LED range will appeal to architects and consultants alike who require a flexible, innovative and discreet approach to emergency lighting. The EYECON LED is designed around the market-leading American manufactured CREE LED. Configured in a single 1 watt configuration, the EYECON/CREE combination offers an impressive 120 lumens during emergency operation. The operational life of the high power CREE LED’s is 50,000 hours. This equates to approximately five and a half years continuous operation. The long operational life of an LED lamp is in stark contrast to the expected life of a conventional 8 watt fluorescent Emergency luminaire Typical power consumption Typical cost per unit of electricity Typical running cost per fitting per annum Conventional NM 8 watt emergency luminaire 5.5 watts €0.18 KWh €8.67 EYECON 2.3 watts €0.18 KWh €3.62 Based upon a site of 200 luminaires, the EYECON fitting offers a long term operational cost saving of over €1,000 per annum. This operational cost savings combined with the additional cost saving of never having to perform any re-lamping of emergency fluorescent lamps makes the long term cost savings to client considerable. SAMPLE SPECIFICATION lamp which is approximately 5000 hours. • Surface mount discreet interior escape route and open plan emergency luminaire for non-maintained selfcontained applications. In addition, if the EYECON LED needs to be embedded into a very inaccessible place, using the EYECON LED virtually eliminates the need for routine lamp replacement. • There is really no cost comparison between the cost of the EYECON LED versus traditional fluorescent lamp options. Flame retardant ABS plastic housing designed to optimise light distribution for escape route and open plan applications. With fluorescent lamps, the true cost of the lamp is the cost of replacement lamp plus the labour expense and time needed to replace them - which can be considerable. Add to this the potential for interruptions to the workplace during these mandatory maintenance procedures and the costs escalate even further. These costs are significant factors with ever increasing operational costs, especially where there are a large number of • Lamp head that meets the 8500C glow wire test that makes the unit suitable for defined escape routes. • Custom made aluminum heat sink to maximise LED illuminous efficacy and LED lamp life. installed luminaires. For office buildings and large installations, maintenance costs to replace lamps can be considerable. This issue can be virtually eliminated • Offering an impressive 120 lumens in emergency operation. • High temperature sealed nickel metal hydride batteries. sustainable emergency lighting solution. • Housing dimensions -140mm diameter * 48mm high. Nickel-metal hydride (Ni-Mh) batteries are commonly considered to • Detachable lamp head allowing a seamless aesthetically pleasing with the EYECON LED. In addition to the cost savings the EYECON LED offers, the product range also offers the client an environmentally friendly and exterior body with no exterior fixing screws. have lower environmental impact than conventional nickel cadmium (Ni-Cd) batteries, due to the absence of toxic cadmium. • 20mm cable entry point on the rear of the product. • Ventilux five year product as standard. • Designed and manufactured to meet the requirements of EN61347-2-7, EN60598-2-22 and all applicable EU The LED produces no infra red radiation hence making them suitable for light sensitive applications such as art galleries and clothes shops and lastly, LED’s have a further environmental advantage in that they contain no environmentally hazardous mercury, unlike fluorescent lamps. standards. VENTILUX manufactures and supplies an extensive range of emergency lighting, standby power and fire detection equipment. The company pays close attention to the quality, specification and construction of its products and is able to offer a comprehensive system design capability to allow the effectiveness of each installation to be maximised. With Ventilux installations operating worldwide, the company works in close association with distributors and a number of specialist emergency lighting conversion centres throughout its market. UNIT 2 ASHGROVE INDUSTRIAL ESTATE KILL AVENUE DUN LAOGHAIRE COUNTY DUBLIN IRELAND TELEPHONE +353 (0)1 214 8800 FACSIMILE +353 (0)1 280 5729 E-MAIL [email protected] ARBOUR COURT ARBOUR LANE KNOWSLEY IND EST LIVERPOOL L33 7XE UNITED KINGDOM TELEPHONE +44 (0)151 546 4155 FACSIMILE +44 (0)151 546 3987 E-MAIL [email protected] www.ventilux.ie www.ventilux.co.uk Order Code EYNM3/LED Mode of operation Non-maintained Input voltage (other voltages upon request) 230V +6% -10% 50/60Hz Battery charger Constant current nominal charge current 85mA Inverter 350mA constant current driver Lamp 1 watt WHITE CREE LED - 50000 hr Lamp colour Cool white - 5000K Charging monitor High intensity GREEN LED Recharge period 24 hours full recharge (14 hours for 1 hour duration) Degree of protection IP20 Lamp head dimensions (mm) 140mm dia * 48mm high Battery type Rechargeable high temperature NiMh 4.8V 1300mAh AA cell battery Power consumption 2.3VA Cable entry 3 way fused terminal block Terminal block fuse rating 3.0 amps Maximum incoming cable size cross sectional area mm2 Single 2.5mm2 or two 1.5mm2 cables Emergency duration 3 hours Lumen level in emergency 120 lumens Luminaire class Class II Weight 1.1kg Standards EN61347-2-7, EN 60598-2-22, (BSEN4544. 102. 22) Environment 00C to 300C up to 80% relative humidity N5XP compatible no AUTOTEST compatible no Base colour Standard white (RAL 9016) other colours available upon request Warranty period 5 years - please note the batteries are excluded from this warranty. Spacing table for EYECON ESCAPE ROUTE (minimum 1 lux) EYNM3/LED Mounting height Transverse to Wall Transverse to Transverse 2.0 m 2.80 m 6.30 m 2.5 m 3.00 m 7.40 m 3.0 m 3.10 m 8.00 m 4.0 m 3.00 m 8.50 m Spacing table for EYECON OPEN PLAN (minimum 0.5 lux) EYNM3/LED Mounting height Transverse to Wall Transverse to Transverse 2.0 m 3.20 m 6.90 m 2.5 m 3.80 m 8.20 m 3.0 m 4.10 m 9.30 m 4.0 m 4.30 m 11.10 m THE EMERGENCY LIGHTING This publication is provided to outline specification details of Ventilux product and is not deemed to form any part of any offer or contract. We adopt a policy of continuous product and services improvement and we reserve the right to vary details without prior notice. SPECIALISTS Doc no:- SAL-209-02