Rustic Tricycle Planter

Transcription

Project: Rustic Tricycle Planter
Page 1 of 21
Rustic Tricycle Planter
Make the parts by following the given documentation and weld them together. Grind the welded
beads to look smooth. Paint the whole structure with the basic preserving color and when it dries
out, daub it two times with color for metal. The recommended color is black, because black color
gives the impression of a wrought iron to the whole structure and it adjusts well to almost any
exterior or interior.
The measurements within this text and 2D documentation are given both in millimeters and
inches (in brackets). This website is based on ISO measurement unit system, which is the
international standard. I apologize to the people who use other measurement units; but I believe
that measurements given in millimeters and inches should be adequate for everyone who would
like to build this project.
Use various tools and clamps in process of welding, so you could weld the parts together with
accuracy.
Project from WWW.CRAFTSMANSPACE.COM
Parts List
Page 2 of 21
Assembly Drawing
Page 3 of 21
Page 4 of 21
Page 5 of 21
Page 6 of 21
Page 7 of 21
Page 8 of 21
Page 9 of 21
Page 10 of 21
Page 11 of 21
Page 12 of 21
Page 13 of 21
Page 14 of 21
Page 15 of 21
Assemblage Instructions
1. Form the back wheels by welding the Small Wheel (part 1) and Small Wheel Spiral (part 2) together.
You will need two of these subassemblies.
Weld the Back Axle (Part 5) between the subassemblies from the previous step.
2. Weld the Vertical Holders (Parts 11) to the subassembly made in the previous step.
3. Weld the Small Wheel (Parts 1) to the subassembly made in the previous step.
Page 16 of 21
Page 17 of 21
4. Form the Front wheel by welding the Big Wheel (part 3) and Big Wheel Spiral (part 4) together.
5. Weld the Front Axle (part 6) to the Front Frame Bars (parts 7).
6. Weld the subassembly made in step 5 to the subassembly made in the previous step.
7. Weld the Front Frame Holder (Part 9) to the subassembly made in the previous step.
Page 18 of 21
8. Weld the Handlebars (Part 8) to the subassembly made in the previous step.
9. Weld the Small Wheel (Part 1) to the subassembly made in the previous step.
Page 19 of 21
10. Weld the Frame Bars (Parts 10) between subassemblies from step 4 and 10.
Weld the Small Wheel (Part 1) between the Frame Bars (Parts 10)
Page 20 of 21
Page 21 of 21

Rustic Tricycle Planter

Transcription

Similar documents

Garden Tricycle Planter