Removing Fender Frontman 15r Back panel
Transcription
Removing Fender Frontman 15r Back panel
Removing Fender Frontman 15r Back panel Removing Fender Frontman 15r Back panel Written By: Greg Sawers INTRODUCTION Need to get inside the amp? Remove the back panel! TOOLS: Phillips #1 Screwdriver (1) Plastic Opening Tools (1) Spudger (1) © iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 3 Removing Fender Frontman 15r Back panel Step 1 — Back panel Be sure to unplug the device before proceeding. Use a Phillips #0 screwdriver to remove the four 21.7mm screws holding the back panel to the frame. Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose. Step 2 © iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 3 Removing Fender Frontman 15r Back panel Step 3 Once the top is separated, use your hand to remove the back panel from the unit. To reassemble your device, follow these instructions in reverse order. This document was last generated on 2016-09-16 06:11:34 AM. © iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 3
Similar documents
Power Mac G4 M5183 Main Fan Replacement
Remove the screw from each of the two niches on lower part of fan using the Phillips #1 screwdriver.
More information