Whirlpool Airbath System III Combination Airbath
Transcription
Whirlpool Airbath System III Combination Airbath
A7236 Last Update 10/1/06 Always check the website for the most updated specifications: www.zumacollection.com 72 64 36 47 28 25 20 11/2 3 21 23/8 17 157/8 Dia. 20 93/4 All bathtub dimensions are ± 1/2”. Tub pictured with optional waste and overflow. ELECTRICAL REQUIREMENTS We recommend one 20 amp ground fault circuit interrupter (GFCI) for each power supply provided with the bathtub. CODES AND COMPLIANCE Products meet or exceed the following standards: • Underwriters Laboratories (UL) • Underwriters Laboratories - Canada (cUL) • ANSI Z124.1 • ANSI A112-19.7 • ANSI A112.19.8 DIMENSIONS 72” x 36” x 21” deep Whirlpool Operating Gallons = 48 Gallons to Overflow = 78 Combination Whirlpool (pump and blower location only) B P P Airbath System II Airbath System III B P PUMP DUAL SUCTION B B BLOWER JET ON/OFF CONTROL O P T I O N A L A C C E S S O R I E S Chromotherapy Light Grab Bars Inline Heater Pillow Angle Full Back Head & Shoulder Support Head Support Open Back Suction Cup Rotar y Jets Waste & Over flow Undermount Yes x No ACCESS PANEL (MINIMUM 16” x 20”) INSTALLATION TIPS • Install product according to our Owners Manual and local codes. • All units with an Airbath III may be 1 1/2 - 2 1/2” higher than stated. OPERATING LITERS • All whirlpool or AirbathTM units require an access panel. • Hot water supply should be 65-75% of tub capacity or greater. Always consult your local plumber for recommendations as installations will vary. • When ordering for undermount installation, always advise us to assure there are no issues with deck mounted controls. • For oval or specialty shapes, Zuma recommends you wait until you have the actual unit or contact us for a template.
Similar documents
Zuma Manual 2012.indd
All building materials and wiring should be routed away from the pump body or other heat producing components of the unit.
More information