cOppEr-FIN II POOL HEATER sTarT-up cHEcKlIsT

COPPER-FIN II POOL HEATER START-UP CHECKLIST
Job Name: _____________________________________________
Model Number: ________________________________________
Address: _____________________________________________
Serial Number: ________________________________________
City: _______________________ ST: _______ Zip: ________
Start-up Date: ________________________________________
OVERVIEW
Retrofit
New Project
How many units are
installed at this location?
Boiler(s):
_____________
Water Heater(s):
_____________
Inspect gas pipe, regulator
and meter sizing.
Y
Is it sized correctly for
Btu/Hr requirement?
N
Total Equiv. Length
Gas Piping:_____________
Gas Supply
Gas Pipe Dia. (in.):
water SUPPLY
_____________
Is there an inlet gas lockup
regulator on the supply?
If Yes, is it ten feet
upstream from the
appliance?
Y
N
Y
N
Water Pipe
Dia. (in.):
_________________
Set Point:
_________________
Differential:
_________________
Record in. of water column -
At full fire, read and record -
Static Pressure: _____________
Inlet Temp: _________________
Dynamic Pressure: _____________
Outlet Temp: _________________
Manifold Pressure: _____________
electrical
Supply Voltage:__________
Total
Amp Draw: __________
External Remote?
Which contacts are used?
Ws
Wp
R
Other:______________
Delta T: _________________
Air
Pres. Differential:_____________
venting (Select the venting option being used):
Outdoor
Conventional venting - Single pipe vertical termination
E-Rite Sidewall direct vent - Two pipe sidewall termination
Powered Sidewall - Single pipe sidewall termination
Powered DirectAire Horizontal - Two pipe sidewall termination
DirectAire Vertical w/rooftop inlet - Two pipe vertical termination
DirectAire Vertical w/sidewall inlet - Single pipe vertical and
single pipe sidewall termination
Other: __________________________________
Combustion and Ventilation Openings:
Two openings to outside
Two ducts from outside
One opening to outside
Two ducts from interior space
Combustion & Vent
Louver Openings
Clearance between
Openings (total sq. in.):
(total sq. in.):
inlet & outlet (DV):
______________
______________
______________
Comments/Corrections for air inlet piping, openings, or venting:
VENTILATION
Air Inlet
Dia. (in.): ____________
Air Inlet
Material:
____________
Total Eqv.
Length (ft.):____________
Flue Dia.
(inches): ____________
Flue
Material:
____________
Total Eqv.
Length (ft.): ____________
Y
N
COMBUSTION
Low Fire:
High Fire:
O2 % ____________________________
CO ppm____________________________
CO2 %
____________________________
Draft Readings
Record in. of water column -
Unit On:
_____________
Unit Off:
_____________
Barometric Dampers
properly adjusted?
Y
N
This Startup Sheet is for use only by a qualified heating installer/service
WARNING ! technician. Refer to the Installation and Operation Manual for your reference.
Have this unit serviced/inspected by a qualified service technician, at least annually. Failure to
comply with the above could result in severe personal injury, death, or substantial property damage.
_____________________________________________________
Start-up performed by:
_____________________________________________________
clearances Measure and record (inches) the service clearances from the
Company:____________________________________________
nearest obstruction (min. 24” required for service):
Name:
____________________________________________
Front: __________
L Side: __________Top: __________
Phone:
____________________________________________
Rear: __________
R Side: __________
Start-up approved by:
Corrections needed or General Job Notes:
Company:____________________________________________
_____________________________________________________
Name:
____________________________________________
_____________________________________________________
Phone:
____________________________________________
Send completed form to:
Email:[email protected]
Internal Use:
S/O #:
_____________________
Fax:
(615) 882-2963
Routed:
_____________________
Service Dept/Lochinvar
300 Maddox Simpson Pkwy.
Lebanon, TN 37090
Tech:
_____________________
Mail:
— The information on this form verifies operation of the Lochinvar product only. —
This does not imply other system components or overall system operation is certified. Component and
system verification should be performed by the designated commissioning agent or installing contractor.
Save Then Submit Form
App:Denied:
CPX-STARTUP REV A