installation instructions

Part Number:
35128
INSTALLATION INSTRUCTIONS
Mortise Hardware
Read the legend below in order to easily
Tools Required
NOTE: handle style shown
may vary by model, however,
the installation steps will be
the same.
• Phillips screwdriver #2
• Hex Key (provided)
Handle Parts Illustration
follow along and install your hardware. If
needed, the hardware assembly is illustrated
on the right.
Interior Escutcheon
Handle
Hole Plug
Hex Key
Retaining Clip
Spindle
Washer
Legend
Bushing
1
3
2
Inse
rt
Bushing
Follow the steps in
order, from 1 to 11.
Key
Cylinder
Red objects are the
action items for that step.
#10-32x1-3/4
Pan Head Screw
#10-32x1-1/2
Flat Head Screw
Instructions in the yellow
MUST READ! boxes are IMPORTANT!
Note: A right hinge
installation is illustrated
in each step.
START
Lockbody factory
installed
4
S
l
i
d
e
Assemble:
Exterior handle,
black bushing,
exterior escutcheon, and
flat washer.
Latch Bolt
Dead Bolts
Tighten set screw.
Tight
en
1
#8-32x1-1/2
Flat Head Screw
Handle
Exterior
Escutcheon
Hex Key
(provided)
2
Secure with
retaining clip.
Choose your
exterior handle.
3
Scroll handles point
down ...
5
Lift up lockbody.
Insert key cylinder.
Insert
spindle.
... whereas
non-scroll exterior
handles are taller ...
ert
Ins
Qty. 1
Black
Bushing
Qty. 1
Flat
Washer
Qty. 1
Retaining
Clip
Turn-knob faces
interior side
Lift
Up
Continued on page 2
Continued from page 1
Qty. 1
Lift
Up
Black
Bushing
6
Exterior
Assembly
Loosely assemble:
interior handle,
black bushing,
interior escutcheon,
and exterior assembly.
Factory
Drilled
Holes
Secure with screws.
Then, hold handles together
and tighten interior set screw.
8
“Lock Assembly Bag”
color matched to door
located in hardware kit
Lift
Up
Qty. 2
#8 x 3/8”
Flat Head Screw
Qty. 1
Hole Plug
Qty. 1
#10-32 x 1-1/2”
Flat Head Screw
9
Hex Key
ss
Pre
ss
Pre
Qty. 2
Remove and
discard
shipping plate
and screws.
n
te
Tigh
7
Secure with fasteners - in the following order.
Escutcheon Screw
#10-32 x 1-3/4” Pan Head
color matched to hardware
and
ove
Remiscard
D
y
essar
if Nec
t
s
u
j
Ad
Use
UPPER
Factory
Drilled
Holes
2
10
Position trim plate using
the UPPER holes.
11
Secure with screws.
Adjust if necessary.
Qty. 2
“Lock Assembly Bag”
color matched to door
located in hardware kit
#8 x 3/8” Flat Head Screw
Finished
with the hardware
installation.
Return to Page 8 of
your “Owners Manual
and Installation
Guide” to complete
the installation.