Serenity - Club Scrap

September 2012 Greetings to Go
Serenity
Materials:
□ Serenity Greetings to Go
□ Serenity Unmounted (UM) Borders & Backgrounds and FontArt
□ Serenity Unmounted Greetings
□ Serenity Unmounted Art Nouveau
□ Serenity Club Scrap® Unmounted Stamps
□ Serenity Stencil
Tools and Supplies:
□ 12” Paper Trimmer
□ CS® Grid Ruler
□ CS® India Black, White Pigment, Topaz and
Sapphire Inks
□ Gray Ink
□ Adhesive
□ Foam Adhesive
□ Tape
□
□
□
□
□
□
Scissors
Paper Piercing Tool and Cork Board
Watercolor Crayons
Water Misting Bottle
Craft Sheet
Stapler and Staples
Notes:
Remove the Blue Pattern and Light Gray die cuts from the parent sheets.
If you do not have an item required to complete a card, simply omit the step or substitute the item.
All rights reserved ©2012, Club Scrap, Inc.
(888) 634-9100 • www.clubscrap.com • email: [email protected]
September 2012 • Serenity Greetings to Go • Page 2 of 6
Set A: 4¼x5½” Lemon Cards with 3x5½” Dark Gray and 2¾x5½” Light Gray Panels
Card #1
□
□
□
Lemon Card with Dark Gray and Light Gray Panels
Unmounted Borders & Backgrounds
Dragonfly Brad
1. Stamp the UM quote onto the Dark Gray panel with White Pigment
ink.
2. Set the brad into the lower center of the panel.
3. Nest onto the Light Gray panel with about 1/2” showing past the right
edge of the Dark Gray panel; layer onto the card.
Card #2
□
□
□
□
Lemon Card with Dark Gray and Light Gray Panels
Blue Pattern Die Cut: “Thank You.”
Unmounted FontArt
Blue Organza
1. Stamp the UM border onto the bottom edge of the Lemon
card with Sapphire ink.
2. Staple ribbon to each end of the die cut and layer onto the
Light Gray panel with foam adhesive.
3. Nest the Light and Dark Gray panels onto the card.
Card #3
□
□
□
Lemon Card with Dark Gray and Light Gray Panels
Light Gray Die Cut: “You are on my mind.”
CS® Unmounted Stamps
1. Trim the Light Gray panel vertically at 2” to create a .75”
strip. Thread the strip through the die cut.
2. Stamp the Dark Gray panel with the UM bubble image and
White Pigment ink. Attach the panel and die cut onto the
card.
All rights reserved ©2012, Club Scrap, Inc.
(888) 634-9100 • www.clubscrap.com • email: [email protected]
September 2012 • Serenity Greetings to Go • Page 3 of 6
Card #4
□
□
□
□
Lemon Card with Dark Gray and Light Gray Panels
Light Gray Die Cut: “Happy Anniversary”
Gray Satin Ribbon
Unmounted Borders & Backgrounds
1. Stamp the UM quote onto the Light Gray panel with India Black ink.
Attach to the Dark Gray panel.
2. Loop the ribbon around the left edge of the die cut and secure to the
back of the nested panels. Attach the panels and die cut to the card.
Card #5
□
□
□
□
Lemon Card with Dark Gray Panel
Light Gray Die Cuts: “Happy,” “BDay,” “You are,” and “still
young”
Unmounted Art Nouveau
2x5.5 Light Gray Panel from Set A, Card 4
1. Trim the 2x5.5 Light Gray panel vertically at 1.5 and 1” to
create two 1/2” strips. Thread the die cuts onto the strips,
as shown, and attach to the Dark Gray panel.
2. Stamp the UM border image onto the top and bottom of the
Lemon card with Topaz ink. Layer the panel onto the card.
Set B: 3¼x5¾” Dark Blue Cards with (2) 2¼x5½” Lemon Panels
Card #1
□
□
□
□
Dark Blue Card with Lemon Panels
Light Gray Die Cut: “Wish You Were Here!”
Serenity Stencil
Gray Satin Ribbon
1. Stencil swirls onto the Lemon panels with the stencil
and Sapphire ink.
2. Thread ribbon onto the die cut and attach to the
Lemon panel; wrap ribbon ends around to the back.
3. Nest the panels onto the card flaps.
All rights reserved ©2012, Club Scrap, Inc.
(888) 634-9100 • www.clubscrap.com • email: [email protected]
September 2012 • Serenity Greetings to Go • Page 4 of 6
Card #2
□
□
□
□
Dark Blue Card with Lemon Panels
Blue Pattern Die Cut: “Thinking of You.”
UM Art Nouveau
Blue Organza Ribbon
1. Stamp the UM water droplet image onto the Lemon
panels with Topaz ink.
2. Thread the ribbon through the die cut and attach to the
panel; secure ribbon ends to the back of the panel with
tape.
3. Attach the panels to the card flaps.
Card #3
□
□
□
□
Dark Blue Card with Lemon Panels
Light Gray Die Cuts: “Happy,” “Birthday,” and “my friend”
UM Borders & Backgrounds
Blue Organza Ribbon
1. Stamp the UM image onto the Lemon panels with Sapphire ink.
2. Wrap the right edge of the die cuts around the edge of one Lemon panel. Staple
ribbon to the left edge of each die cut.
3. Adhere the panels to the card flaps.
Card #4
□
□
□
□
Dark Blue Card with Lemon Panels
Blue Pattern Die Cut: Ribbon Slide
Gray Satin Ribbon
UM Greeting
1. Stamp the UM swirl image onto the Lemon panels
with Topaz ink.
2. Stamp the UM greetings onto the panels with India
Black ink.
3. Tie a bow around the die cut ribbon slide and
attach to the panel. Layer the panels onto the card
flaps.
Card #5
□
□
□
□
□
Dark Blue Card with Lemon Panels
Blue Pattern Die Cut: “I am so sorry.”
(3) Dragonfly Brads
UM Greeting
Blue Organza Ribbon
1. Stamp the UM greeting onto the edge of one
Lemon panel with Sapphire ink.
2. Thread ribbon through the die cut, attach the die
cut to the panel and wrap ribbon ends around to
the back. Add three brads to the panel.
3. Adhere the panels onto the card flaps.
All rights reserved ©2012, Club Scrap, Inc.
(888) 634-9100 • www.clubscrap.com • email: [email protected]
September 2012 • Serenity Greetings to Go • Page 5 of 6
Set C: 5x7” Light Blue Cards with 4¼x6¼” Dark Blue and 4x6” Blue Pattern Panels
Card #1
□
□
□
□
Light Blue Cards with Dark Blue and Blue Pattern
Panels
Light Gray Die Cuts: “With Deepest Sympathy” and
Circle
Gray Satin Ribbon
UM Art Nouveau
1. Stamp the Blue Pattern panel with the UM swirl image
and Sapphire ink. Nest onto the Dark Blue panel and
card.
2. Tie the ribbon around the left edge of the die cut and
layer onto the circular die cut. Trim the right edge from
the die cut and attach to the lower right corner of the
card.
Card #2
□
□
□
□
Light Blue Cards with Dark Blue and Blue Pattern Panels
CS® Unmounted Stamps
Light Gray Die Cut: Circle
Dragonfly Brad
1. Stamp the Light Blue card with the UM text, bubbles, and “believe”
images and Sapphire ink.
2. Stamp the UM quote onto the Blue Pattern panel with Sapphire ink.
Stamp the swirl, but first stamp onto a separate sheet of paper to
remove some of the ink to create a softer image.
3. Nest the panels, and attach the die cut circle to the top right corner with
the dragonfly brad.
4. Nest the panels onto the card.
Card #3
□
□
□
Light Blue Cards with Dark Blue and Blue Pattern Panels
UM Borders & Backgrounds
UM Greeting
1. Stamp the UM image onto the Blue Pattern panel with gray ink. Stamp
the UM greeting with India Black ink.
2. Nest the panels onto the card.
All rights reserved ©2012, Club Scrap, Inc.
(888) 634-9100 • www.clubscrap.com • email: [email protected]
September 2012 • Serenity Greetings to Go • Page 6 of 6
Card #4
□
Light Blue Cards with Dark Blue and Blue Pattern
Panels
Blue Pattern Die Cut: “Make a Difference”
UM FontArt
Blue Organza Ribbon
□
□
□
1. Stamp the UM image onto the Blue Pattern panel
with gray ink. Nest onto the Dark Blue panel.
2. Thread ribbon onto the die cut and attach to the
panel; wrap ribbon ends around to the back and
secure with tape.
3. Nest the panels onto the card.
Card #5
□
□
□
□
□
Light Blue Cards with Dark Blue and Blue Pattern
Panels
Blue Pattern Die Cut: “Happy Birthday” (Plain
Side)
Gray Satin Ribbon
Serenity Stencil
UM Borders & Backgrounds
1. Mist the stencil with water and color the stencil
with a blue watercolor crayon. Press the Blue
Pattern panel onto the colored stencil to transfer
the image. Allow the panel to dry.
2. Stamp the UM images onto the panel with India
Black ink. Nest onto the Dark Blue panel.
3. Stamp the UM greeting onto the plain side of the
die cut. Thread with ribbon, attach to the panel,
and secure ends to the back of the panel with
tape.
4. Center the panels onto the card.
All rights reserved ©2012, Club Scrap, Inc.
(888) 634-9100 • www.clubscrap.com • email: [email protected]