Instruction Guide - Merchants Overseas, Inc.

DESIGN PROJECT
HALLOWEEN
NECKLACE “GLAMOROUS BAT”
HALLOWEEN
NECKLACE “GLAMOROUS BAT”
SWAROVSKI ELEMENTS
Product Group
Article No.
Supplies & Tools
Amount
Size
Color
Color Code
Supplies
Buttons
3014
2 pcs.
12 mm
Jet Hematite
280 HEM
Buttonhole silk, black, 2 m
Buttons
3017
2 pcs.
12 mm
Jet
280
1x Jump ring, silver, 5mm
Beads
5000
3 pcs.8
mm
Crystal
001
Beads
5000
4 pcs.8
mm
White Alabaster
281
Beads
5000
7 pcs.8
mm
White Opal
234
2x Crimping tube, silve r
1x Jump ring, silver, 7mm
Lace, black, 25x13c m
1x Lobster clasp, silve r
Resin clear
Crystal Pearls
5810
90 pcs.8
mm
Crystal Ivory Pearl
001 708
2x Split ring, silver,
Tiger tail, silver,
5mm
0,3mm, 110c m
Tools
Crimping pliers
Double sided tape
Flat nose pliers
1x Paint brush, A 4
1x Plastic wrap, A 4
Pins
Sheet of paper
Sewing needl e
Scissors
Side cutte r
STEP 1: Connect a lobster clasp to a 5mm jump ring and then to one 5mm split ring using fl at nose pliers. Open a 7mm jump
ring and connect it to the other 5mm split ring.
STEP 2: Cut 110cm of tiger tail and slide on a crimping tube. Thread it through a 5mm split ring which is connected to the
lobster clasp, thread it back through the crimping tube and crimp the tube. Cut off the extra tiger tail. Slide the Beads and Crystal
Pearls from the SWAROVSKI ELEMENTS assortment onto the tiger tail as shown in the illustrations. Slide on a crimping tube
at the other end. Thread the tiger tail through the 5mm split ring which is connected to the 7mm jump ring and thread it back
through the crimping tube. Crimp the crimp tube and cut off the extra tiger tail.
STEP 3: Draw the pattern or cut out the illustrations according to the sizes shown in the illustrations.
STEP 4: Stick double sided tape on the back of the pattern, place it over the lace and cut it out.
STEP 5: Put the lace bat on top of a piece of plastic wrap and strengthen it by applying resin using a paint brush. Dry it overnight.
STEP 6: Attach the lace bat onto the necklace with pins.
(not shown to scale)
STEP 7: Cut 1m of buttonhole silk and make four back stitches on the bat. Stitch over to
the top of the bat and insert one of the Sew-on Stones from the SWAROVSKI ELEMENTS
assortment onto the bat as shown.
Attach the bat to the pearl and bead strand by winding the silk around and between the
Crystal Pearls as you stitch on the Sew-on stone.
Repeat this step three times with the other three Sew-on stones from the
SWAROVSKI ELEMENTS assortment as shown attaching both sides of the bat pattern onto
the necklace.
1m
Repeat x2
Repeat Step x3
Shown Complete
www.MerchantsOverseas.com