CXN Airboat Pod Manual

Airboat
Pod
Clear CA Glue or EPOXY Recommended
ABS has FLAT and HAIRCELL sides,
make sure you glue the pieces by
looking at the pictures.
We recommend using hot glue at the end
of the stainless steel nut/screw, it will keep it
together and it’s easier to take apart than
using loctite or ca glue on the treads.
Pod has been designed to use 9” inch props
and a variety of motors 3S or 4S.
The pod is designed to hold in place a
Plano 3449 Case
(Walmart and Amazon sells them cheap)
you can just double tape the box to the pod
and make holes to pass the ESC power wires.
Screw will tap the ABS and hold in place,
don’t overtight, let the rudder move freely.