Printable PDF - Urschel Laboratories, Inc.

Urschel® Model CCL
Lattice Slicer
1
2
3
MODEL CCL
SPECIFICATIONS
OPERATING PRINCIPLE
The Model CCL is equipped with manganese aluminum bronze
contact parts.
Product delivered to the feed hopper enters the revolving impeller
assembly [ 1 ] consisting of four rotating potato holding tubes [ 2 ].
The tubes allow the potato to be rotated in a vertical axis while being
revolved in a radial direction. Centrifugal force holds the potatoes tightly
against the inside surface of the spherical-shaped slicing head. As the
potatoes rotate inside the slicing head, they make an approximate
one-quarter turn between each of the four crinkle knife stations [ 3 ].
This results in intersecting crinkles on each side of the slice.
Length: . . . . . . . . . . . . . . . . . . . . . 48.03" (1220 mm)
Width: . . . . . . . . . . . . . . . . . . . . . . . 35.26" (896 mm)
Height: . . . . . . . . . . . . . . . . . . . . . . . 32.68" (830 mm)
Net Weight: . . . . . . . . . . . . . . . . . . . . 540 lb (245 kg)
Motor: . . . . . . . . . . . . 2 HP (1.5 kW) or 5 HP (3.7 kW)
APPLICATIONS
The Model CCL slicer produces lattice cuts of varying thickness. Both
sides of the slice have crinkles, with the crinkles on each side of the
slice running approximately 90° to each other. Uses involve lattice
potato chips and thicker potato waffle fries.
Lattice slicing is a unique application. Proper feeding of the machine
is necessary to ensure continuous production. Tempered high quality
oval or flat shaped potatoes measuring between 2 – 4 inches (51 –
102 mm) are best-suited.
Note: The Model CC Slicer can be converted to a Model CCL Lattice
Slicer by purchasing the recommended set of parts. Contact your local
Urschel representative for more information.
TYPES OF CUTS
Fine Lattice: Translucent appearance
with small lattice holes visible after
frying. 8 corrugations per inch (25.4
mm). Approximately .125" (3.2 mm)
peak to peak.
Coarse Lattice: Small lattice holes
visible. 5.7 corrugations per inch (25.4
mm). Approximately .175" (4.4 mm)
peak to peak.
Deep Lattice: Slightly larger lattice
holes. 2.25 corrugations per inch (25.4
mm). Approximately .446" (11.2 mm)
peak to peak.
If your product application is not mentioned on this page, contact your local Urschel representative to determine the most effective solution to your size reduction needs.
Urschel® Model CCL Slicer
Dimensional Drawing
You Are Invited to Test Cut Your Product
Urschel Laboratories has a complete network of test facilities and
experienced service and sales representatives around the world
ready to work for you on any size reduction application. Contact your local Urschel Laboratories’ representative to schedule
a comprehensive, no-obligation test today at www.urschel.com.
®Urschel is a registered trademark of Urschel Laboratories, Inc.
|
L2555
September 2013
(s.s. L2030)